Lindy 25008 manual Port Configuration, 10FDX

In the “System Configuration” menu, you can setup the following settings.

Item	default	explanation
Password	admin	The login password.
	(A string)
Aging time	300	Forwarding table aging period
	(Integer, in seconds)	Aging Time value is between 0~65000.
Logout time	0	Set the automatic logout time. The console will be
	(Integer, in minutes)	automatically logged out if idle time period over this
		setting.
		Logout Time value is between 0~255.
Auto refresh time	12	Many console screens contain data that can be
	(Integer, in seconds)	updated constantly. This parameter controls the time
		between each screen update.
		Auto Refresh Time value is between 0~255.

7.3Port Configuration

When you go into the “Port Configuration” sub-menu, the current state will be scanned for all 8 ports of the Switch and shown on the screen as follow:

PggFobcmfeBvupTubuvtuvtDpogjh!!!!Tu>>>>>>>>>>>>!Vtf!!njo!UzqfbsuTxjudi;QpsuDpogjhvsbujpo!Dpogjhvsf!!!bsspx!!!!!!!=Sfuvso!?!lfztu!ui.!Oh!!21IEY!!DvssfouGmpxf!!!!p!qpsu!tubuvt/npwf/!=Tqbdf?Uzqf!DpouspmTubuvt!!!!!!up!!Pgg!nblf!!!!!!!!!!dibohf/Pgg!Gmpx!Dpouspm!}SFBE0TFMFDU!
The!!!!!!!!!!!!!!!!!!1!!!QpsuMjolBe98765432/.....................................................................Port Configuration Screen provides configurable setting and current status for each port. For each Ethernet port, following
settings are available:
Item	Type	default	selections	Explanation
Port	R	N/A	N/A	You can select from 1 to 8 port for setting up.
Link Status	R	N/A	N/A	Port Link status If the port links, it shows “On”
				else “Off”
Admin	R/W	Enabled	Enabled	Port transmission enable/disable.
Status			Disabled
Type Config	R/W	Auto-Nego	Auto-Nego	Preferred Port speed and duplex setting.
				Auto-Negotiation
			10HDX	10BASE-T, Half-Duplex mode
			10FDX	10BASE-T, Full-Duplex mode
			100TX-HDX	100BASE-TX, Half-Duplex mode
			100TX-FDX	100BASE-TX, Full-Duplex mode
			1GB-FDX	1000BASE-T, Full-Duplex mode
Current Type	R	N/A	N/A	Current Status of the link speed and duplex
				with link partner.
Flow Control	R/W	Off	Off	Flow control mode selection.
				No Flow-Control
			BothWay	Accept Pause frame and issue Pause frame.
			SendOnly	Only issue Pause frame and ignore received
				frame.
			Rcv/BothWay	Accept Pause frame and issue Pause frame,
				same as Bothway.
Flow Control	R	N/A	N/A	Current Flow control result with link partner.
Status
Users can only monitor following items: Link Status					Current Type Flow Control Status.
Users can set up the following items: Admin Status					Type Config / Flow Control

12