IOGear GDIP201 manual Federal Communications Commission FCC Statement

Page 68

Federal Communications Commission (FCC) Statement

15.21

You are cautioned that changes or modifications not expressly approved by the part responsible for com- pliance could void the user’s authority to operate the equipment.

15.105(b)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

68

Image 68
Contents Installation Guide Page Table of Contents Package Contents Hardware Installation Page Page Page Page USB Server Software Installation XP Explore Page Page DisplayLink- software installation XP Right click on the CD-ROM drive and select To start the DisplayLink software installation DisplayLink software is now installing GDIP201 Full Software Installation XP Page DisplayLink installation Windows XP Utility Setup Click on Install the software automati Page Page Connecting to a DVI Monitor XP Page Page Video Mode Configuration XP Page Mirror Mode Page Extended Mode Page Disconnecting the DVI Net ShareStation XP USB Server Software Installation Vista Double click on the Vista folder To start the Vista installation, double click on Click on Finish to complete the installation process DisplayLink- software installation Vista Right click on the CD-ROM drive and select To start the DisplayLink software installation Computer. Click YES to restart GDIP201 Full Software Installation Vista Click OK to start the installation process Click on Finish to complete the installation process Installation program will start, click Page GDIP201 Configuration -Vista Page Page Page Connect to DVI Net ShareStation Vista Page Video Mode Configuration Vista Mirror Mode Page Mirror Mode Page Disconnecting the GDIP201 Vista Setting the Polling Interval Widows -XP On File Settings Polling IntervalWeb Management Interface Device webpage Page Upload Firmware Page Page Page Federal Communications Commission FCC Statement Operation is subject to the following two conditions CE Statement Limited Warranty Contact IOGEAR, INCPage FUN