and click “Next”. |
|
8. Select “Search for the best driver for your device(Recommended)”. | Click |
“Next”. |
|
9.Select “Floppy disk drives” and uncheck the other boxes and click “Next”, Select “The Updated driver (Recommended)” NEC USB Open Host Controller, and click “Next”, then click “Next” to continue.
10.If display “Insert Disk” (please insert the disk labeled windows 98 second Edition
11.The Hardware wizard will display that it found “PCI Universal serial Bus”, and click “Next”.
12.Select “Search for the best driver for your device (Recommended)”. | Click |
“Next”, |
|
13.Make sure the “ Specify a location: “ checkbox is only checked, and insert the “Driver CD” in your
14.Points specify a location, example E:\USB2.0 Host\NEC\Win98_me. Click “OK”, and click “Next”. (If your
15.When the wizard indicates that it found a driver for the device, click “Next”. Then click “Finish” to exit the wizard.
16.The Hardware wizard will display that it found “PCI Ethernet Controller”, click “Next”, select “Search for the best driver for your device (Recommended)”, click “Next”, Check “Specify a location”, uncheck the other boxes,
17.Insert the “Driver CD” in your
18. Points specify a location, example E:\10_100_1000NIC\RTL8169 \WIN98se, and click “OK” then “Next”.
19.Click “Next” if display “Insert Disk” (please remove the Driver CD from your
20.When install driver finish, please remove windows 98 Second Edition
2.5. Windows ME installation
1.Power off the system. Insert Combo Card into an available PCI slot. Power up the system.
2.The Hardware wizard will display that it found “PCI Universal Serial Bus”, Select
“Specify the location of the driver (Advanced)”, and insert the “Driver CD” in your
- 6 -