Lindy 20704, 20703 manual English Manual, Lindy GigapatchPanel, Preparation of the cable

English Manual

LINDY GigapatchPanel

The LINDY GigaPatchPanel is supplied with 16 or 24 Cat 6 ports. The new modular construction allows you to install the panels with any even number of ports between 2 and 24, partially equipped panels can be extended or completed with the addition of dual modules at any time. This means that the valuable space inside your rack can be fully optimised, for the future expansion of your network.

The newly developed LSA-rct technology allows a fast and reliable connection of the wires to the terminals. Each unit is supplied with a suitable crimping tool, however there is also a premium tool available which allows you to connect 4 wires simultaneously and thus helps to increase efficiency and lower the costs of the network installation.

?Up to 12 shielded dual RJ45 Cat 6 modules per unit

?PCB-terminals optimised for fast data transfer

?Strain relief’s are attached - so they won’t get lost

? Additional strain relief by use of a cable tie is possible			2-Port-PCB
?	Coding scheme both, EIA/TIA 568 A and B	Module Cover	Terminals
?	Crimping tool supplied

? Connection via LSA-rct terminals ? Cores with 22-24 AWG can

be accommodated ? Pairs can be lead

directly to the terminals

–no need to untwist them

Ground Connector

Strain Relief

Preparation of the cable	Shielding Contact
	Chassis
	Foil- or Braid shielded cable

Cut away the outer sheath by approx 65mm with a cable or sharp knife. Make sure to cut only as deep as the shielding allows, don’t damage the insulation of the wires!

Cut the foil or the braid shielding as shown in the

picture so that you leave approx 10mm of the shielding. Wind the shielding wire around the 10mm left of the shielding, it will be clamped later beneath the strain relief.

If present, shorten the shielding foil of the single pairs (Pimf-cable only) to the same length. Untwist the pairs for 13mm at most and connect the wires using the following colour scheme

untwist 13 mm at most

NEXT – Pairs 1,2 – 3,6

NEXT – Pairs 3,6 – 4,5