Lindy 70540 user manual Windows NT 4.0 Driver Installation, For Existing Windows ME Systems

Page 7

8.Remove the Driver diskette and click Yes to restart Windows to complete driver installation.

For Existing Windows ME Systems

1.After the SATA RAID PCI Host Adapter and attached drives are configured, boot up Windows.

2.At the Add New Hardware Wizard, check Specify the location of the driver (advanced), and click Next.

3.Insert the Driver diskette, check Specify a location, uncheck the other boxes, type in A:\, and click Next.

4.Click Next and then Finish.

Verification of the Proper Installation for Windows 98/98SE/ME

1.Double click My Computer/Control Panel/System. Click Device Manager tab.

2.Double click SCSI Controllers, Silicon Image Sil-3112 SATA Raid Controller

should be listed.

3.Highlight Silicon Image Sil-3112 SATA Raid Controller and click Properties. A message This device is working properly is displayed in the dialog box, the driver has been correctly installed. If any error message is displayed, remove Silicon Image Sil-3112 SATA Raid Controller and restart your system.

4.3. Windows NT 4.0 Driver Installation

For New Windows NT 4.0 System

1.After the SATA RAID PCI Host Adapter and attached drives are configured, follow Microsoft procedures to install Windows accordingly.

2.At the Windows Set-upscreen, press F6 to specify and add the driver.

3.Press S, select Other, then press Enter.

4.Insert the Driver diskette and press Enter.

5.Select Silicon Image Sil-3112 SATA Raid Controller Driver and press Enter.

6.Press Enter to continue and follow on-screen instructions to complete Windows NT

4.0installation.

Add Windows NT 4.0 Driver on Original Booting Device

1.After the SATA RAID PCI Host Adapter and attached drives are configured, boot up Windows. Double click My Computer/Control Panel/SCSI Adapters, then click the Drivers tab.

2.Click Add… then Have Disk....

3.Insert the Driver diskette into the floppy drive and type in A:\, then click OK.

4.Highlight Silicon Image Sil-3112 SATA Raid Controller and click OK.

- 7 -

Image 7
Contents Lindy No Low Profile Sata RAID 2 Port PCI HostIntroduction FeaturesPackage Contents What Is RAIDCreating Striped Sets RAID Bios Installation RAID SettingCreating Mirrored Sets RAID Resolving Conflict Software InstallationDeleting RAID Sets Rebuilding Mirrored SetsFor Existing Windows 98/98 SE Systems Windows 98/98SE Driver InstallationWindows ME Driver Installation For New Windows 98/98 SE SystemsFor New Windows NT 4.0 System Windows NT 4.0 Driver InstallationAdd Windows NT 4.0 Driver on Original Booting Device For Existing Windows ME SystemsWindows XP Driver Installation Windows 2000 Driver InstallationVerification of the Proper Installation for Windows 2000/XP Add Windows XP Driver on Original Booting Device