'System Properties ' , select 'Device Manager', right click on the '?PCI RAID controller' and select 'Properties' from the context menu.
6.Click 'Driver', 'Update Driver' and select 'Automatic search for a better driver [Recommended] '. Insert the driver diskette into floppy drive. Click 'Next' and complete the driver installation.
7.System will go through the enumeration process and install the driver. At the end of the process, click 'Yes' to reboot your system.
8.See instructions in section 4.8 to verify controller was installed correctly.
4.6. Windows 98SE installation
1.Power off the system. Insert Combo Card into an available PCI slot. Power up the system.
2.During the system boot up, the Hardware Wizard will display that it found a 'PCI standard
3.Select 'Floppy disk drives' and click 'Next'.
4.When the wizard indicates that it found a driver for the device click 'Next'.
Then click 'Finish' to exit the wizard.
5.The Hardware wizard will display that it found 'NEC USB Open Host Controller', click 'Next'.
6.Select 'Search for the best driver for your device (Recommended)' and click 'Next'.
7.Select
8.Select 'The Updated driver (Recommended)'. NEC USB Open Host Controller, and click 'Next'. And click 'Next' to continue.
9.If display 'Insert Disk' (please insert the disk labeled windows 98 second Edition
10.The Hardware wizard will display that it found 'NEC USB Open Host Controller', and click 'Next'.
11.Select 'Search for the best driver for your device (Recommended)'.
Click 'Next'.
12.Select
13.If display 'Insert Disk' (please insert the disk labeled windows 98 second Edition
14.The Hardware wizard will display that it found 'PCI Universal serial Bus', and click 'Next'.
15.Select 'Search for the best driver for your device (Recommended)'. Click 'Next', and insert CD driver into
- 9 -