Linksys WPS54G configurationmanual Connect the PrintServer, Configure the PrintServer

®

A Division of Cisco Systems, Inc.

Package Contents

• Wireless-G PrintServer

• Setup Wizard CD-ROM

• User Guide on CD-ROM

• USB 2.0 Cable

• Network Cable

• Power Supply

• Quick Installation

• Registration Card

2.4802.11gGHz Wireless-G

		PrintServer
	Wireless	Quick Installation
Model No.	WPS54G

1 Connect the PrintServer

Before starting the physical
installation, note the PrintServer’s
default name. The default name is
shown in the Server field on the
sticker located on the PrintServer’s
back panel.
A Use the USB cable to connect
	your USB printer to the
	PrintServer’s USB Printer port.	A
B	If you are connecting the
	PrintServer to your wired
	network, then plug one end of
	the Ethernet network cable into
	the PrintServer’s Ethernet port.
	Then connect the other end to
	your router or switch.
C	Power on your printer.	C
D Plug the power adapter into
	the PrintServer’s Power port.
	Then plug the other end into
	an electrical outlet.
		D

2 Configure the PrintServer

A Insert the Setup CD-ROM into
the computer’s CD-ROM drive.
The Setup Wizard should run
automatically. If it does not,
click Start and choose Run. In
the field that appears,
enter D:\setupWizard.exe (if
“D” is the letter of your
CD-ROM drive).
B On the Welcome screen, click
Setup Wizard.	B
C The Setup Wizard will search for
the PrintServer. After it has been
found, the Wireless-G
PrintServer Setup screen will
appear. If this is the first time
you have run the Setup Wizard,
make sure that List only new
(unconfigured) Print Servers is
selected and your PrintServer is
listed by its default server	C
name. If you have previously
configured the PrintServer,
select List all compatible Print
Servers. Click Next.
D On the Basic Settings screen,
you may change the Device
Name and Domain Name
settings if you want. Then
click Next.

D

E The IP Settings screen will appear. If your network uses a router that automatically assigns IP addresses, select Automatically obtain an IP address (DHCP) and click Next. If you need to assign the PrintServer a static IP address, select Set IP configuration manually, and enter the IP Address, Subnet Mask, and Gateway in the fields provided. Then click Next.

F On the Set PrintServer’s Password screen, enter the PrintServer’s default password, admin, in the Current Password field. Enter a new password in the New Password field, and enter it again in the Verify Password field.

Click Next.

G On the Wireless Settings screen, enter your wireless network’s SSID or name. If your network is set to ad-hoc mode, select the channel at which the network broadcasts its wireless signal. For the Network Type setting, select infrastructure if the PrintServer will communicate using an access point or wireless router. Select Ad-Hoc if the PrintServer will communicate directly with wireless-equipped computers. Click Next.

E

F

G