Barco quick start DX-700 Module Insertion, DX-700 Module Removal, Rear View

1

DX-700 Module Insertion

Ensure that DX-700 power is off.

Orient the module so that the power connector is

Carefully insert the module, and push it into the

3 chassis until the module’s top latch stops against the chassis.

Retaining Screw Chassis

Simultaneously push both latches towards the

5 center of the module, until the module is fully seated against the chassis.

CAUTION	Always push both latches
	simultaneously.

2 at the bottom.

Rear View:

• System Module

• Input Module

• Output Modules

Note

The rear panels of all

three DX-700

modules are identical.

Latch

Insert module until the latch stops against the chassis

Module

Raise the top latch until you can slide the module

4 farther into the chassis — up to the latch’s pivot point.

Simultaneously push both latches toward the center of the module

Power Connector

Raise latch, slide module farther in, until it stops against pivot point

Pivot

Point

Tighten both retaining screws to secure the

6 module.

DX-700 Module Removal

1	Ensure that DX-700 power is off.
2	Loosen both retaining screws on the module.

Simultaneously push both latches away from the

3 center of the module.

CAUTION	Always push both latches
	simultaneously.

When both latches are clear of the chassis,

4 remove the module.