Elo TouchSystems 2125C Series manual Mechanical, Optical, Environmental

Page 35

Table C.1 IntelliTouch Touchmonitor SpecificationS

Mechanical

Positional Accuracy

Standard deviation of error is less than 0.080 in. (2.03 mm). Equates to less

 

than ±1%.

Touchpoint Density

More than 100,000 touchpoints/in2 (15,500 touchpoints/cm2).

Touch Activation Force

Typically less than 3 ounces (85 grams).

Surface Durability

Surface durability is that of glass, Mohs’ hardness rating of 7.

Expected Life

No known wear-out mechanism, as there are no layers, coatings, or moving parts.

Performance

IntelliTouch technology has been operationally tested to more than 50 million

 

touches in one location without failure, using a stylus similar to a finger.

Sealing

Unit is sealed to protect against splashed liquids, dirt, and dust. See IntelliTouch

 

Product Manual for details.

Optical

Light Transmission (per ASTM D1003)

Visual Resolution

Gloss (per ASTM D2457 using a 60-degree gloss meter)

90%

All measurements made using USAF 1951 Resolution Chart, under 30X magnification, with test unit located approximately 1.5 in (38 mm) from surface of resolution chart.

Clear surface: Excellent, with no noticeable degradation.

Antiglare surface: 6:1 minimum.

Clear surface: N/A

Antiglare surface: Curved: 60 ± 20 gloss units or 75 ± 15 gloss units.

Environmental

Chemical Resistance

The active area of the touchscreen is resistant to all chemicals that do not affect

 

glass, such as:

 

Acetone

 

Toluene

 

Methyl ethyl ketone

 

Isopropyl alcohol

 

Methyl alcohol

 

Ethyl acetate

 

Ammonia-based glass cleaners

 

Gasoline

 

Kerosene

 

Vinegar

Electrostatic Protection

Meets Level 4 (15 kV air/8 kV contact discharges).

(per EN 61 000-4-2, 1995)

 

Mechanical

 

Construction

Top: Polyester with outside hard-surface coating with clear or antiglare finish.

 

Inside: Transparent conductive coating.

 

Bottom: Glass substrate with uniform resistive coating. Top and bottom layers

 

separated by Elo-patented separator dots.

C-29

Image 35
Contents Page User Guide Copyright 2001 Elo TouchSystems Inc. All Rights Reserved Page Table of Contents Page About the Product PrecautionsIntroduction Page Unpacking Your Touchmonitor Installation and SetupSelecting a Suitable Location Installing the BaseGetting Started Video cable Connecting Your TouchmonitorPower cable Video cable Power cable Installing the Driver Software Page Page Operation About Touchmonitor AdjustmentsTouchmonitor Controls Using the On Screen Display OSDLocking/Unlocking the OSD Functions OSD Adjustments OSD H Degauss Brightness Suggestion s TroubleshootingProblem Message Suggestion Problem Suggestion sMonitor Warning Messages Touchscreens An Overview Touch TechnologyIntelliTouch Touchscreens AccuTouch Touchscreens Page Touchmonitor Safety Care and Handling of Your Touchmonitor Regulatory Information Electrical Safety InformationDhhs Touchmonitor Specifications Technical SpecificationsTouchmonitor Specifications EMI Environmental MechanicalOptical Table C.2 AccuTouch Touchmonitor Specifications CRT Touchmonitor Dimensions 70 mm 2.75484.5 mm PIN Number Signal Signal Pinout for 21 MonitorConsumption W Power ConsumptionMonitor Power Mode Horizontal Resolution Frequency Refresh Rate Preset Timing TableSetting the Refresh Rate Page Warranty Page Index