VocoPro DA-3600Pro2 owner manual Connecting Speakers, Connecting to a TV or Display Device

Getting Connected

Connecting Speakers

Either using MDP (banana plug) speaker cables or standard speaker wires, connect speakers paying attention to correctly match the polarities (+/-). Connect speakers rated no lower that 4-Ohms to the DA-3600 Pro. Please do not try to connect more than one speaker per channel, as the load may exceed the amplifiers handling capacity, causing it to overload. If using standard speaker wire, unscrew each plastic bind till you are able to see an interior hole for speaker wire (easier to locate when viewing from a side angle). Slide the speaker wires into the slots and tighten the plastic binds to tighten them in place. Be sure there is no insulation on the speaker wire preventing conductivity.

DA-3600 Pro Speakers

110-120V220-240V￿

voltage selector

AC IN 110-120V￿220-240V￿50/60Hz

WWW.VOCOPRO.COM LA VERNE CALIFORNIA U.S.A.

CAUTION:

TO REDUCE THE RISK OF FIRE RELPACE WITH ONLY THE SAME TYPE AND RATING OF FUSE.

ATTENTION:

UTILISER UN FUBIBLE DE RECHANGE DE MEME TYPE.

NOTE: DO NOT CONNECT MORE THAN

ONE SPEAKER PER SPEAKER JACK

SPEAKER SYSTEM

+ L -

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

+ R - MODEL NO.

SERIAL NO. 20010-9300-0

MADE IN CHINA

VIDEO OUT		VIDEO IN
OUT	CDG DVD		QA:3
			PASS
OUT		INPUT	EFFECT
OUT REC	LINE	DVD CDG	OUT IN
			L
			R

BLACK WIRE	RED
	WIRE

Connecting to a TV or Display Device

There are 3 ways to get video from the DA-3600 Pro to a TV or display device:

a)Connect an RCA video cable from the VIDEO OUTPUT jack on the DA-3600 Pro to the VIDEO INPUT jack on ￿ the TV. Some TV’s will require that you manually switch the TV to the VIDEO INPUT mode. Other TV’s will ￿ automatically switch to the video mode when they detect a video signal at the video input jack.

On most TV’s the jack is labeled AUX or VIDEO.

b)If the TV does not have a VIDEO INPUT jack you may connect that end of the cable to the VIDEO INPUT of a ￿

VCR and connect the RF OUTPUT of the VCR to the TV ANTENNA INPUT jack.

c)If there is no VCR present, you will need to use an RF Modulator. To obtain an RF Modulator, check with your ￿ VocoPro dealer. An RF Modulator can also be purchased from Radio Shack™ .

DA-3600 Pro
		NOTE: DO NOT CONNECT MORE THAN			VIDEO OUT	VIDEO IN
		ONE SPEAKER PER SPEAKER JACK			OUT	CDG DVD	QA:3
		SPEAKER SYSTEM
110-120V	220-240V￿						PASS
		+	L	-
voltage selector				CAUTION	OUT	INPUT	EFFECT
				RISK DO NOT OPEN
				OF ELECTRIC SHOCK

			OUT REC LINE DVD CDG OUT	IN
	WWW.VOCOPRO.COM			L
	LA VERNE CALIFORNIA
	U.S.A.			R
	CAUTION:	+ R -	MODEL NO.
	TO REDUCE THE RISK OF FIRE
	RELPACE WITH ONLY THE SAME		SERIAL NO. 20010-9300-0
AC IN	TYPE AND RATING OF FUSE.
	ATTENTION:
110-120V￿	UTILISER UN FUBIBLE DE		MADE IN CHINA
220-240V￿	RECHANGE DE MEME TYPE.
50/60Hz

(c)

RF Modulator

(a)

TV/MONITOR

TO VIDEO IN

VCR

VIDEO/ANT OUT

(b)

15