Dukane 8406A user manual Regulation & Safety Notices, FCC notice

Page 68

Appendices

Regulation & Safety Notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

67English

Image 68
Contents DLP Data Video Projector User’s Manual Table of Contents Safety Information Usage NoticePrecautions Do not Eye Safety Warnings Product FeaturesIntroduction Package OverviewProduct Overview Main UnitControl Panel Input/Output Connections Installation Remote ControlConnecting the Projector Connect to Computer/NotebookConnect to Video Sources Powering the projector On / Off Powering On the ProjectorPowering off the projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting the Projector’s Zoom / Focus Adjusting Projection Image SizeXGA Control Panel & Remote Control User ControlsUsing the Remote Control VGA Using the Help button User Controls User Controls How to operate On-screen Display MenusMenu Tree ImageOptions Contrast Display ModeBrightness Tint SharpnessColor Color Settings GammaBrilliantColor Color TempColor Space Input SourceDisplay FormatLBX Edge Mask ZoomImage Shift KeystoneDisplay 3D 3D Sync. InvertProjection LanguageScreen Type Volume Menu LocationProjector ID MuteWireless RS232Phase AutomaticFrequency PositionSecurity Security TimerChange Password User Controls Closed Captioning LogoLogo Capture Network State IP AddressSubnet Mask GatewayHow to use web browser to control your projector Click Change settings of this connection Crestron RoomView Control Tool For more information, please visit Reset Source LockHigh Altitude Information HideDirect Power On Auto Power Off minSleep Timer min Power Mode StandbyBrightness Mode Lamp ResetLamp Hours Lamp ReminderTroubleshooting AppendicesImage is unstable or flickering Image is reversed Projector stops responding to all controls On Screen Messages Replacing the lamp Lamp Replacement Procedure Compatibility Modes  Computer CompatibilityMode Resolution Sync Hz Sync KHz  Video CompatibilityRS232 Commands and Protocol Function List RS232 Pin AssignmentsRS232 Protocol Function List Send to projectorLBX Send to emulate Remote Send from projector automatically English English English Regulation & Safety Notices FCC noticeRemarque à l’intention des utilisateurs canadiens