Canon 5100 owner manual Preparation Positioning the Projector, Adjustable Feet

PREPARATION

POSITIONING THE PROJECTOR

●This projector is designed to project on a flat projection surface.

●The projector can be focused from 4.6’(1.4m) ~ 26.3’(8.0m).

●Refer to the figure below to adjust the screen size.

ROOM LIGHT

The brightness in the room has a great influence on the picture quality. It is recommended to limit ambient lighting in order to provide the best image.

			26.3’ (8.0m)
		19.7’ (6.0m)		200”
	13.1’ (4.0m)	150”
			Max. Zoom
	7.8’ (2.4m)			167”
4.6’ (1.4m)	100”			H1
		125”
	60”
36”	83”		Min. Zoom
	50”
30”				H2

Screen Size	30”	60”	100”	150”	200”
(W x H) mm
	610 x 457	1219 x 914	2032 x 1524	3048 x 2286	4064 x 3048
Height (H1)	16.61”(422mm)	33.2”(844mm)	55.4”(1407mm)	83.1”(2110mm)	110.8”(2814mm)
Height (H2)	1.38”(35mm)	2.8”(70mm)	4.6”(117mm)	6.9”(176mm)	9.2”(234mm)

ADJUSTABLE FEET

Picture tilt and projection angle can be adjusted by rotating the ADJUSTABLE FEET. Projection angle can be adjusted to 7.6 degrees.

1	Lift the front of the projector and pull the FEET LOCK
	LATCHES on both sides of the projector.
2	Release the FEET LOCK LATCHES to lock the
	ADJUSTABLE FEET and rotate the ADJUSTABLE FEET
	to fine tune the position and the tilt.
3	To shorten the ADJUSTABLE FEET, lift the front of the
	projector and pull and undo the FEET LOCK LATCHES.

The position and the keystone distortion of the image can be adjusted using the Menu Operation. (Refer to P 20, 28 and 30.)

ADJUSTABLE FEET

FEET LOCK

LATCHES

9