| Crestron CNHBLOCK |
CNHBLOCK With Mounting Plate
1 | 2 | 3 | 4 |
| 24 |
| 24 |
| Y |
| Y |
| Z |
| Z |
| G |
| G |
CRESTRON |
|
| |
A | B | C | D |
| 24 |
| 24 |
| Y |
| Y |
| Z |
| Z |
| G |
| G |
5 |
| 6 | 7 | 8 |
| 24 |
|
| 24 |
| Y |
|
| Y |
| Z |
|
| Z |
| G |
|
| G |
|
| POWER | Y | Z |
E |
|
|
|
|
| 24 | a | b | c |
|
|
|
| |
| Y |
|
|
|
| Z |
|
|
|
| G |
|
|
|
CNHBLOCK | ALL CONNECTORS ARE IN PARALLEL |
Rack Installation
The CNHBLOCK may also be installed into a rack by using a CNXRMAK (not supplied). Perform the following steps to install the CNHBLOCK into a rack. The only tool required for this procedure is a #2 Phillips screwdriver.
1.Using a #2 Phillips screwdriver, remove the four mounting screws (shown below) that secure the mounting plate to the CNHBLOCK and remove the plate.
Detach Mounting Plate
2.For further instructions, refer to the latest revision of the CNXRMAK Installation Guide (Doc. 8156). This document can be obtained from the Downloads page (MANUAL Library) of Crestron’s website (www.crestron.com). Search for CNXRMAK.PDF. New users are required to register in order to obtain access to the FTP site
4 ∙ | Operation & Installation Guide - DOC. 8157 |