Explanation of Symbols
The following symbols are used throughout this Service Manual.
Symbols | Explanation |
| Symbols | Explanation |
|
|
|
|
|
| Check. |
|
| Remove the claw. |
|
|
| ||
|
|
|
| |
| Check visually. |
|
| Insert the claw. |
|
|
| ||
| Check the noise. |
|
| Use the bundled part. |
|
|
| ||
| Disconnect the connector. |
|
| Push the part. |
|
|
|
The following rules apply throughout this Service Manual:
1. Each chapter contains sections explaining the purpose of specific functions and the | ||||||||||
relationship between electrical and mechanical systems with reference to the timing of | ||||||||||
operation. |
|
|
|
| ||||||
In the diagrams, |
|
|
|
|
|
|
| represents the path of mechanical drive; where a signal name | ||
|
|
|
|
|
|
| ||||
accompanies the symbol, the arrow |
| indicates the direction of the electric | ||||||||
| ||||||||||
signal. |
|
|
|
| ||||||
The expression "turn on the power" means flipping on the power switch, closing the | ||||||||||
front door, and closing the delivery unit door, which results in supplying the machine with | ||||||||||
power. |
|
|
|
| ||||||
2. In the digital circuits, '1' is used to indicate that the voltage level of a given signal is | ||||||||||
"High", while '0' is used to indicate "Low". (The voltage value, however, differs from | ||||||||||
circuit to circuit.) In addition, the asterisk (*) as in "DRMD*" indicates that the DRMD | ||||||||||
signal goes on when '0'. |
|
|
|
| ||||||
In practically all cases, the internal mechanisms of a microprocessor cannot be checked | ||||||||||
in the field. Therefore, the operations of the microprocessors used in the machines | ||||||||||
Connect the connector.
from the cable guide or wire
saddle.
Plug the power cable.
Turn on the power.
are not discussed: they are explained in terms of from sensors to the input of the DC |
controller PCB and from the output of the DC controller PCB to the loads. |
The descriptions in this Service Manual are subject to change without notice for product improvement or other purposes, and major changes will be communicated in the form of Service Information bulletins.
Set the cable/wire to the cable guide or wire saddle.
Remove the screw.
Tighten the screw.
All service persons are expected to have a good understanding of the contents of this Service Manual and all relevant Service Information bulletins and be able to identify and isolate faults in the machine.
fineline6