Dell S300W manual Using Your Projector, Turning Your Projector On, Turning Your Projector Off

3

Using Your Projector

Turning Your Projector On

NOTE: Turn on the projector before you turn on the source (computer, DVD player, etc.). The Power button light blinks blue until pressed.

1 Remove the lens cap.

2 Connect the power cord and appropriate signal cables. For information about connecting the projector, see "Connecting Your Projector" on page 9.

3 Press the Power button (see "Using the Control Panel" on page 27 to locate the Power button).

4 Turn on your source (computer, DVD player, etc.)

5 Connect your source to the projector using the appropriate cable. See "Connecting Your Projector" on page 9 for instructions to connect your source to the projector.

6 By default, the input source of projector is set to VGA-A. Change the input source of projector if necessary.

7 If you have multiple sources connected to the projector, press the Source button on the remote control or control panel to select the desired source. See "Using the Control Panel" on page 27 and "Using the Remote Control" on page 29 to locate the Source button.

Turning Your Projector Off

NOTICE: Unplug the projector after properly shutting down as explained in the following procedure.

1 Press the Power button.

NOTE: The "Press Power Button to Turn off Projector" message will appear on the screen. The message disappears after 5 seconds or you can press the Menu button to clear it.

2 Press the Power button again. The cooling fans continue to operate for 120 seconds.

22

Using Your Projector