Delta Electronics PG-04 instruction sheet Installation, For 1-5HP For 7.5 HP and above

Page 5

1-5 Installation

For 1-5HP

For 7.5 HP and above

Step 1: Insert 3 PCB supports into control board.

Step 2: Press the PG card on the control board to be fixed to tighten the 3 screws with a torque of 4-6kgf-cm. If the PG card is not fixed on the control board, it may cause screw idle running and cannot turn the screw into supports.

Image 5

Contents Explanations of the terminals of PG-04 Card PG-04 AppearanceDCM Z1, Z1 A2, A2 B2, B2Wiring Notes Line driver encoder Wiring ExamplesRecommended Wiring for Resistors For 1-5HP For 7.5 HP and above InstallationFJP1 Corresponding output types of encoder