Delta Electronics Q48SR manual Mechanical Drawing, Pin No Name Function

Page 13

MECHANICAL DRAWING

Pin No.	Name	Function
1	-Vin	Negative input voltage
2	ON/OFF	Remote ON/OFF
3	+Vin	Positive input voltage
4	+Vout	Positive output voltage
5	+SENSE	Positive remote sense
6	TRIM	Output voltage trim
7	-SENSE	Negative remote sense
8	-Vout	Negative output voltage

Notes:

1Pins 1-3, 5-7 are 1.00mm (0.040”) diameter

2Pins 4 and 8 are 1.50mm (0.060”) diameter

3All pins are copper with tin plating

13

Image 13

Contents Features Parameter Technical SpecificationsElectrical Characteristics Curves Typical input characteristics at room temperature Electrical Characteristics Curves Output voltage noise and ripple measurement test setup Vin=48V Input Source Impedance Design ConsiderationsFeatures Descriptions Output Voltage Adjustment Trim Features Descriptions CONThermal Considerations Thermal Testing SetupThermal Curves Thermal DeratingThermal Curves CON Pin No Name Function Mechanical DrawingModel List Part Numbering System