Delta Electronics H48SL manual Mechanical Drawing, Name, Function, Pin Specification, Pin No

Page 13

MECHANICAL DRAWING

MECHANICAL DRAWING

Pin No.	Name	Function
1	-Vin	Negative input voltage
2	Case	Case ground
3	ON/OFF	Remote ON/OFF
4	+Vin	Positive input voltage
5	+Vout	Positive output voltage
6	+SENSE	Positive remote sense
7	TRIM	Output voltage trim
8	-SENSE	Negative remote sense
9	-Vout	Negative output voltage
Pin Specification:
Pins 1-4, 6-8	1.00mm (0.040”) diameter
Pins 5 & 9	2.00mm (0.079”) diameter

All pins are copper with Tin plating.

DS_H48SL1R560_10302006

13

Image 13

Contents OPTIONS FEATURESAPPLICATIONS DATASHEET DSH48SL1R56010302006INPUT CHARACTERISTICS TECHNICAL SPECIFICATIONSOUTPUT CHARACTERISTICS DYNAMIC CHARACTERISTICSELECTRICAL CHARACTERISTICS CURVES For Positive Remote On/Off Logic For Negative Remote On/Off LogicFigure 5 Turn-on transient at zero load current 2 ms/div. Top Figure 7 Turn-on transient at zero load current 2 ms/div. TopFigure 8 Output voltage response to step-change in load current 75%-50%-75% of Io, max di/dt = 0.1A/µs. Load cap 10µF, tantalum capacitor and 1µF ceramic capacitor. Top Trace Vout 100mV/div, Bottom Trace Iout 10A/div. Scope measurement should be made using a BNC cable length shorter than 20 inches. Position the load between 51 mm to 76 mm 2 inches to 3 inches from the module Figure 13 Output voltage noise and ripple measurement test setup Figure 14 Output voltage ripple at nominal input voltage and THERMAL CURVES NO HEATSINK, EITHER ORIENTATION Soldering and Cleaning Considerations Safety ConsiderationsDESIGN CONSIDERATIONS Input Source ImpedanceOver-Current Protection FEATURES DESCRIPTIONSOver-Voltage Protection Over-Temperature ProtectionOutput Voltage Adjustment TRIM FEATURES DESCRIPTIONS CON⎝ ∆% THERMAL CONSIDERATIONS Thermal Testing SetupThermal Derating MECHANICAL DRAWING Pin SpecificationName FunctionPART NUMBERING SYSTEM WARRANTYMODEL LIST MODEL NAME