Compaq uSign 200, uSign 100 user manual uSign User Manual, Table of Contents

		uSign User Manual
Table of Contents
1.0	Introduction		6
2.0	Features		6
3.0	Model Designations		7
4.0	Installing uSign		7
4.1	Communication Interface		8
4.2	USB-CDC Setup		10
5.0	Terms & Abbreviations		7
6.0	Specifications		10
6.1	Power requirement		10
6.2	Physical housing uSign 100		10
6.3	Physical housing uSign 200		11
6.4	LCD screen & Resistive touch pad		11
6.5	Communication interface		11
6.6	LED	.......................................................................................................	11
6.7	Agency Approvals		11
6.8	Electronics MTBF		11
6.9	Electro-Static Discharges (ESD)		11
6.10	Environmental		11
7.0	uSign commands description		13
7.1	Command protocol:		13
7.2	System Commands		13
7.2.1		Get firmware version	13
7.2.2		Get serial number	13
7.2.3		Get clip area	13
7.2.4		Set clip area	13
7.2.5		Clear clip area	13
7.3	One byte commands		14
7.3.1		Stop Capturing	14
7.3.2		Start Capturing use FBP format 1	14
7.3.3		Start Capturing use FBP format 2	14
7.3.4		Turn red led on	14
7.3.5		Turn red led off	14
7.3.6		Clear CMP format mode data	14
7.3.7		Get data 0x00	14
7.3.8		Start Capturing use CMP format	14
7.3.9		Reset points counter	14
7.3.10		Get point counter high byte	14
7.3.11		Get point counter low byte	14
7.3.12		Start Capturing use FBP format 0	15
7.4	Multi-byte commands		15
7.4.1		Initialize device	15
7.4.2		Get PW120 Version	15
7.4.3		Test device	15
7.4.4		Set CTS control	15
7.4.5		Set interval between two points	15

Copyright © 2006, International Technologies & Systems Corp. All rights reserved.

Page 4 of 18