Linux Installation and Configuration Guide for AlphaServer | 44 |
System Resource Manager Configuration
There are several pieces of information that you need to configure in the SRM subsystem, as well as device identifiers that you should make note of, prior to beginning the installation process. The steps that follow take you through that process.
Power up your system. After several diagnostics are completed, you will be presented an SRM prompt "P00>>>", as shown here:
256 | Meg of system memory |
|
|
|
| |
probing hose 1, PCI |
|
|
|
| ||
bus 0, | slot 9 | Network Controller | ||||
probing hose 0, PCI |
|
|
|
| ||
probing |
| |||||
bus 0, | slot 5, function | 1 | dqa | |||
bus 0, | slot 5, function | 2 | dqb | |||
bus 0, | slot 6, function | 0 | pka | |||
bus 0, | slot 6, function | 1 | pkb | |||
bus 0, | slot 7 | ELSA | GLoria Synergy | |||
os_type: UNIX - console | CIPCA driver not started | |||||
System | Temperature is 30 degrees | C | ||||
initializing GCT/FRU at | 1ec000 |
|
COMPAQ AlphaServer DS20E 500 MHz Console
Determine what devices your system has installed. In particular you will need to note your installation device (a floppy and/or
P00>>>show device |
|
|
|
dka0.0.0.6.0 | DKA0 | COMPAQ BA03611C9B | 3B05 |
dka100.1.0.6.0 | DKA100 | COMPAQ BB01811C9C | 3B05 |
dka200.2.0.6.0 | DKA200 | COMPAQ BB01811C9C | 3B05 |
dqa0.0.0.105.0 | DQA0 | 9.5B | |
dva0.0.0.0.0 | DVA0 |
|
|
ewa0.0.0.9.1 | EWA0 |
| |
pka0.7.0.6.0 | PKA0 | SCSI Bus ID 7 |
|
pkb0.7.0.106.0 | PKB0 | SCSI Bus ID 7 |
|
In the output above, the first line shows that DKA0 is a hard disk, DQA0 is a
Also useful for inspecting the computer configuration is the "show config" command, as shown here:
P00>>>show config more
Configure the system SRM parameters to boot from your installation device. The commands for configuring to boot from the floppy device are shown here:
P00>>>set bootdef_dev dva0
P00>>>set boot_file vmlinux.gz
P00>>>set boot_osflags "root=/dev/fd0 load_ramdisk=1"
P00>>>show boot*
boot_dev | dva0.0.0.0.0 |
boot_file | vmlinux.gz |
boot_osflags | root=/dev/fd0 load_ramdisk=1 |
boot_reset | OFF |
bootdef_dev | dva0.0.0.0.0 |
booted_dev |
|
booted_file |
|
booted_osflags |
|
Insert the boot floppy into the drive.
ECG513/0100