Installing the Hub, RJ-45 Ports, Power Connector

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

RJ-45 Ports

There are five RJ-45 MDI-X station ports and one RJ-45 MDI uplink port, each providing a 10 Mb/s Ethernet channel. To connect to a workstation or server, attach straight-through unshielded or shielded twisted-pair cabling to any station port.

To connect to another Netelligent 1005 or compatible hub, attach straight- through twisted-pair cabling to the UPLINK port. You can also connect to another hub by running straight-through twisted-pair cabling from a station port on this hub to a crossover port on the other hub. However, if you must connect to another hub via stations ports at both ends of the cable, use crossover cabling.

NOTE : Using the UPLINK port disables Port 5.

Power Connector

The power adapter plugs into this connector. The power adapter plugs into the main AC power source at 100V, 120V, 220-230V, or 240V at 50 to 60Hz.

Installing the Hub

This section describes different ways of using the supplied hub stand and explains how to attach the hub to devices in your network.

Using the Hub Stand

You can attach and use the hub stand in the following ways:

QTo stand the hub upright on a desk or shelf, slide the stand onto the base of the hub.

QTo lay the hub flat, slide the stand onto the back of the hub.

QTo mount the hub directly on a wall or office partition, first attach the stand to the mounting location with two small screws. Then slide the back of the hub onto the stand.

Compaq Netelligent 1005 10Base-T Hub User Guide