Ask Proxima 9100 manual Vertical Double Image, Faint, Vertical Lines of Distortion

Page 88

Vertical Double Image

Figure 6-4, Adjusting the vertical position

Use the Setup key or the following procedure to adjust the Vert. Pos control:

1Open the Main menu.

2Select Advanced.

3Select Vert. Pos (Vertical Position).

4Press the down arrow key until the image is properly aligned.

Note: There are separate Vert. Pos values for Normal and Fit-to-View Modes. Adjustments in one mode are not made in the other.

If this adjustment does not correct the problem, try a different Source Mode setting. Make sure the selection has the correct resolution and the closest V-sync and H-sync values.

Faint, Vertical Lines of Distortion

1Use the Cyclops remote control to adjust the sync first. If the lines of distortion move uniformly across the screen as you adjust the sync, there is a Dot Clock problem.

2Adjust the Dot Clock SLOWLY so that the shading gets further and further apart, until it is gone. Considerable trial and error may be required to avoid skipping over the correct value.

Dark, Vertical Lines of Distortion

Dark, uniformly spaced vertical lines (sometimes with smaller lines on either side of each dark line) may be seen in Fit-to-View mode or Normal Mode, or both. Any of the following steps may eliminate this problem.

Troubleshooting 6-7

Page 87 Page 89
Image 88
Page 87 Page 89
Contents Multimedia LCD Projector Limitation of Warranties WarrantyFCC Statement TRADEMARKS, PATENTS, and Copyrights Introducing the DP9100 Cyclops Interactive Pointer System Introducing the Mediaexpress SystemWHAT’S in the BOX? Also included but not shownQuick Start Number ItemSetting up the projector Figure i-4, Pressing the lever to release the armFigure i-5, Pressing the lever to release the flip mirror Your fingers Connecting the computer Figure i-7, Connecting the projector to your computerConnecting video and audio To SET this UP Connect this Cable From Here To HereCyclops Remote Control and Control Panel KEY FunctionKeyfunction Setting up your projector Opening the ProjectorTop view and side view of the projector Arm pops up Closing the projector Moving the projectorAccessing the recessed handle Turning on the Projector Connecting the Projector to Your Computer Port Connects to With this CableMIC 11, The projector’s Computer in connector Projecting without an attached monitorPCs Macintosh computersMacintosh Projector 16, Notebook connections Workstations 13C3 Video Connections except Silicon Graphics workstationsSilicon Graphics 13C3 Video Connections DEC 3C3 Video Connections Connecting the Cyclops interactive pointer system Connecting the MediaExpress systemConnecting Video and Audio to the Projector Connecting video from a VCRCable Projector Port VCR Connector C497-6Connecting external speakers Connecting an external stereo system Important Precautions 26, Allow sufficient air flowTurning the lamp on and off 27, The keyFocusing the image Adjusting the ImageRaising or lowering the image Correcting keystoning Image sizeDistance from Screen Diagonal Image Size Ft/1.2 m Inches Ft/1.8 m Ft/2.4 m 10 ft/3.0 m 12 ft/3.6 mUsing your projector Using the Cyclops Remote Control Control PanelSetup key VolumeSource key Prog 1 and Prog 2 keysMenu Lamp on/offArrow keys control panel only Fit-To-View/ MediaExpressOvertemp indicator light Lamp indicator lightSwitching Between Input Sources Using the MenusSaving your settings Reverting to the factory defaultsAdjusting the brightness Changing the language on the menusAdjusting the contrast Adjusting the color tint and saturationAdjusting image position Correcting shimmering or streaksAdjusting the Audio Adjusting Remote Mouse Tracking Presentation FeaturesButton Function Draw toolbarColor selection boxes Setting the timer for audience intermission Projecting transparenciesAdvanced Features Programming the Cyclops remote controlCyclops F/X Saving a user profileMain menu Projector MenusMenu What IT Contains Tools menu USE this To do this OptionCalibrate Cyclops menuButton Source Mode Input Source menuSource Select InputImage menu computer or MediaExpress input SourceImage menu video or S-Video input source Audio menu Audio menuProjection Projector menuLamp Hours Preferences menu ColorsLanguage On-screenAdvanced menu Cyclops F/X Starting Cyclops F/X Installing Cyclops F/XWindows users Assignments Area Cyclops F/X special effectsSetup Remote Customizing EffectsPut Away Edit EffectUsing the Cyclops Interactive Pointer System Cyclops interactive pointer screenEdit Cyclops Navigation screen SEE-IT/SHOW-IT Edit Navigation Keys screenFreeze Edit Freeze Key screenStarting AN Effect Presentation Effects10Chapter Four Menu Commands File menuEffects menu Menu Item FunctionOptions menu Cleaning the Lens and Mirror Cleaning the Projection WindowBlowing air into the projector Replacing the Lamp Removing the old lampInstalling the new lamp Opening the lamp chamber doorCLEANING/CHANGING AIR Filters Accessing the top filterThree left-top retaining screws Accessing the right filters Three bottom screwsThree top cover screws 10, The screws at the top of the right side panel Replacing the Batteries in the Remote Control Temperature ExtremesTroubleshooting Chart Problem Likely Cause Possible SolutionsCannot get entire Image on screenScrambled image Black borderDP9100 Parameter Adjustments Adjusting Contrast and Brightness Adjusting SyncAdjusting the Dot Clock Adjusting the Horizontal PositionAdjusting the Vertical Position Adjusting the VCO GainAdjusting Your Display Horizontal Double ImageAdjusting the half-normal height display Half-Normal Height DisplayFaint, Vertical Lines of Distortion Vertical Double ImageDark, Vertical Lines of Distortion Noise, Flickering Pixels, or Distortion UNKNOWN/UNRECOGNIZED Video SourceCompatibility List Denotes interlaced models EWS21 Where to GET Help ReturnsDP9100 Specifications Replacement Parts Part Part NumberAccessories MediaExpress Image Display SystemConfiguring the Desktop Projector What are Sense LINES?Display Resolution Sense Line Settings Identifying Sense Line SettingsMacintosh Displays Sense line settings for popular video cards Index From Computer Index Index

9100 specifications

The Ask Proxima 9100 is an advanced multimedia projector designed to meet the demands of various presentation environments such as corporate meetings, educational institutions, and home theaters. This projector stands out due to its high-quality image output, user-friendly features, and robust connectivity options.

One of the key features of the Ask Proxima 9100 is its impressive brightness level. With a brightness rating of 4000 lumens, it delivers clear and vibrant visuals even in well-lit environments. This makes it especially suitable for conference rooms and classrooms where ambient light can be challenging. The 2500:1 contrast ratio enhances the depth and clarity of the images, ensuring that colors appear vivid and details remain sharp.

The Proxima 9100 utilizes DLP (Digital Light Processing) technology, which is known for its reliability and high performance. DLP technology offers smooth video playback, making it ideal for displaying multimedia presentations, videos, and even high-definition content. The projector supports various resolutions, including XGA (1024x768), making it adaptable to different display requirements.

In terms of connectivity, the Ask Proxima 9100 comes equipped with multiple inputs, including HDMI, VGA, RCA, and USB ports. This flexibility allows users to connect a range of devices such as laptops, DVD players, and gaming consoles with ease. Wireless connectivity options are also available, enabling seamless presentations without the hassle of cables.

Another noteworthy characteristic of the Proxima 9100 is its built-in speaker system. While external audio equipment can enhance sound quality, the integrated speakers provide a convenient option for smaller presentations or casual viewing. The projector also features a user-friendly interface with an intuitive remote control, making navigation and operation straightforward.

The design of the Ask Proxima 9100 emphasizes portability and ease of setup. Weighing in at a manageable size, it is easy to transport, making it suitable for on-the-go professionals or educators. Its sleek and modern aesthetic ensures that it fits well in any environment.

In summary, the Ask Proxima 9100 is a versatile multimedia projector that combines high brightness, exceptional image quality, and a variety of connectivity options. With its DLP technology, user-friendly features, and portability, it is an ideal solution for anyone looking to deliver impactful presentations or enjoy high-quality visual content.
Top Page Image Contents