Acer ADPC1940-EN-3, F PS 040- RAB, DA-40A19 manual Power saving, Ddc, Light, Blue, EN-8

Page 9

Power saving

The monitor will be driven into Power Saving” mode by the control signal from the display controller, as indicated by the amber-color power LED.

State

LED

Light

 

 

 

ON

Blue

 

 

Power Saving

Amber

Mode

 

 

 

The power saving states will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from Active OFF state back to ON state is around 3 seconds.

DDC

To make your installation easier, the monitor is able to Plug and Play with your system if your system also supports DDC protocol. The DDC (Display Data Channel) is a communication protocol through which the monitor automatically informs the host system about its capabilities, for example, supported resolutions and corresponding timing. The monitor supports DDC2B standard.

EN-8

Image 9
Contents Table of Contents EN-1 Special Notes on LCD MonitorsSafety instructions Information for your safety and comfortSafe listening EN-2LCD Pixel Statement Product servicingTips and information for comfortable use Finding your comfort zoneTaking care of your vision Developing good work habitsEN-4 EN-5 UnpackingScreen Position Adjustment Attaching the BaseEN-6 Safety Precaution Connecting the Power CordCleaning Your Monitor EN-7DDC Power savingLight BluePin Color Display Signal Cable Connector PIN AssignmentGround Ground DDC-Serial ClockEN-10 Pin Color Display Signal CableEN-11 Standard Timing TableEN-12 InstallationEN-13 EN-14 Acer eColor Management Operation instructionsEN-15 Adjusting the OSD settingsEN-16 EN-17 EN-18 EN-19 TroubleshootingEN-20 DVI/HDMI modeDeclaration of Conformity Federal Communications Commission Declaration of Conformity