Connecting the LCD Monitor and Base

Figure 1-3

Figure 1-4

Figure 1-5

Connecting the LCD Monitor and Base

W h e n y o u o p e n t h e b o x t o t a k e t h e b a s e a n d p u t o n t h e d e s k f i r s t . T h e n c o n n e c t t h e L C D M o n i t o r a n d base please . (See fig . 1 - 1 )

Figure 1-1

Viewing Angle Adjustment

T h e L C D M o n i t o r i s designed to allow users to have

ac o m f o r t a b l e v i e w i n g a n g l e . T h e v i e w i n g a n g l e c a n be adjusted from - 5 °t o +3 0 °. (See fig . 1 - 2 )

Figure 1-2

Warning

Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor stand.

Detaching LCD Monitor from Its Stand

Unscrew screws Œ the swivel base support column and pull down• the hinge to release.

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3. The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical

Connecting the Display

1.Power off your computer.

2.Connect one end of the signal cable to the LCD Monitor’s VGA port or DVI port .(For AL712/AL713)(See Fig 1-5)

3.Connect the other end of the signal cable to the VGA port

or DVI port on your PC.

4. Make sure connection are secure.

Attention: This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.