Acer model specifications Detaching LCD Monitor from Its Stand, Interface for Arm Applications

Page 5

Detaching LCD Monitor from Its Stand

1. Unscrew screws of the hinge bracket

2. Remove the stand from LCD monitor (See fig. 1-3)

Figure 1-3

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical

Mounting Interface Standard (paragraphs 2.1

and 2.1.3, version 1, dated 13 November 1997).

Figure 1-4

Connecting the Display to your Computer

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor's VGA port. (See Fig. 1-5)

3. Connect the other end of the signal cable to the VGA port on your PC.

4. Make sure both connections are secure.

Figure 1-5

Attention

This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is

5

ENGLISH

Image 5
Contents Table of Contents Canadian DOC Notice PrefaceFCC Statement Warning Important Safety Instructions Connecting the LCD Monitor and Base InstallationViewing Angle Adjustment UnpackingInterface for Arm Applications Connecting the Display to your ComputerDetaching LCD Monitor from Its Stand Used Power Management System Connecting the AC PowerSetting Up the LCD Monitor User Controls Adjusting the Monitors DisplayDisplay Controls All OSD menus in this manual will stay as Ver Icon Function Function Description Function DescriptionUser Technical Information SpecificationsOSD Format Characters x 9 rows Plug & Play Pin Assignment Standard Timing Table1024x 53.964 66.132 71.664 Problem Troubleshooting