Acer X173 setup guide Installation, EN-12

Page 14

X173

INSTALLATION

To install the monitor to your host system, please follow the steps as given below:

Steps

1.1-1 Connect Video Cable

a.Make sure both the monitor and computer are powered-OFF.

b.Connect the VGA video cable to the computer.

1-2 Digital Cable (Only Dual-Input Model)

a. Make sure both the monitor and computer are powered-OFF. b. Connect one end of the 24-pin DVI cable to the back of the monitor and connect the other end to the computer’s port.

2.Connect power cord

Connect the power cord to the monitor, then to a properly grounded AC outlet.

3.Power-ON Monitor and Computer

Power-ON the monitor first, then power-ON the computer. This sequence is very important.

4.If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the problem.

EN-12

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Safety Instructions Connecting Your Monitor to a ComputerTable of Contents Special Notes on LCD Monitors EN-1Information for your safety and comfort EN-2Product servicing EN-3Taking care of your vision EN-4Unpacking EN-5EN-6 Screen Position AdjustmentAttaching / Removing the Base Cleaning Your Monitor Connecting the Power CordSafety Precaution EN-7LED Power savingDDC EN-8EN-9 Connector PIN AssignmentPIN no Description Hot Plug Detect EN-10MAC Standard Timing TableVGA VesaInstallation EN-12EN-13 User ControlsMenu / Enter EN-14 HOW to Adjust a SettingUser ∙ Adjusting the Picture EN-15EN-16 EN-17 DDC/CIEN-18 LED OFF TroubleshootingLED on EN-19EN-20 Regulations and safety notices FCC noticeLamp Disposal 显示器（液晶及 CRT）Specification Energy StarMENU/ENTER
Top Page Image Contents