Table of Contents |
|
Preface | 1 |
Chapter 1 Installation | 2 |
Unpacking | 2 |
Connecting the LCD Monitor and Base | 2 |
Viewing Angle Adjustment | 2 |
Detaching LCD Monitor from Its Stand | 3 |
Interface for Arm Applications | 3 |
Connecting the Display to your Computer | 3 |
Connecting the AC Power | 3 |
Connecting the Audio Cable | 3 |
Connecting the AV and | 3 |
Setting Up the LCD Monitor | 4 |
Power Management System | 4 |
Chapter 2 Display Controls | 4 |
User Controls | 4 |
Adjusting the Monitor's Display | 5 |
Function Description | 5 |
Chapter 3 Technical Information | 7 |
Specifications | 7 |
Standard Timing Table | 10 |
Troubleshooting | 10 |
Preface
This manual is designed to assist users in setting up and using the LCD Monitor. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer.
FCC Statement Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Warning
Use only shielded signal cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
Canadian DOC Notice
This Class B digital apparatus meets all requirements of the Canadian
Cet appareil numérique de la classe B repecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
1