BOXLIGHT CP-18t manual Appendix, Lamp Replacement

APPENDIX

LAMP REPLACEMENT

LAMP REPLACE

When the life of the Projection Lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly.

This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly.

TOP CONTROL

	G
RNIN
WA	P.
TEM

			P
	M
A					E
L
				C
			A
		L
	P
E
R

VOLUME –

INPUT IMAGE MENU

		CAUTION
Allow a projector to cool, for at least 45 minutes before	For continued safety, replace with a lamp assembly of
you open Lamp Cover. The inside of a projector can	the same type.
become very hot.	Do not drop a lamp assembly or touch a glass bulb! The
	glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

1	Turn off the projector and disconnect the AC plug. Allow the	LAMP COVER
		SCREW
	projector to cool for at least 45 minutes.

2

3

To remove Lamp Cover, remove the screw with a screwdriver.

Loosen 3 screws with a screwdriver and pull out Lamp Assembly by grasping Handle.

4	Replace Lamp Assembly with a new one and tighten 3 screws
	back into position. Make sure that Lamp Assembly is set
	properly. Replace Lamp Cover and tighten the screw.
5	Connect AC Power Cord to the projector and turn on the
	projector.
6	Reset the Lamp Replace Counter.
	Refer to “LAMP REPLACE COUNTER” on the next page .

LAMP	SCREW	HANDLE
ASSEMBLY

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through Boxlight at 1-800-762-5757 or 360-779-7901.

●	Model No. of your projector	:	BOXLIGHT CP-18t
●	Replacement Lamp Type No.	:	POA-LMP35
			(Service Parts No. 610 293 2751)

37