Acer 501 manual Detaching LCD Monitor from Its Stand, Interface for Arm Applications

Page 6

Detaching LCD Monitor from Its Stand

1.Unscrew screws of the hinge bracket

2. Remove the stand from LCD monitor (See fig. 1-3)

Figure 1-3

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat

Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

Figure 1-4

Connecting the Display to your Computer

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor's VGA port. (See Fig. 1-5)

3. Connect the other end of the signal cable to the VGA port on your PC.

4. Make sure both connections are secure.

Figure 1-5

Attention

This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Page Table of Contents Preface FCC Statement WarningCanadian DOC Notice Important Safety Instructions Viewing Angle Adjustment InstallationConnecting the LCD Monitor and Base UnpackingConnecting the Display to your Computer Detaching LCD Monitor from Its StandInterface for Arm Applications Connecting the AC Power Setting Up the LCD MonitorPower Management System Adjusting the Monitors Display Display ControlsUser Controls Function Description Icon Function Function DescriptionUser LCD Panel Hannstar SpecificationsTechnical Information Display Colors VideoSize and Weight Power ManagementPower Supply AC Adapter Sync InputStandard Timing Table Pin AssignmentTroubleshooting Problem
Top Page Image Contents