COMPUTER INPUT
MANUAL PC ADJUSTMENT
This projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by Multi- Scan system of this projector. If this happens, projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a
This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it.
Note : This PC ADJUST Menu cannot be operated when the input signal is from COMPUTER IN DIGITAL terminal or “RGB” is selected on PC SYSTEM MENU (P22).
1 | Press MENU button and |
| POINT LEFT/RIGHT button to move a red frame pointer to PC |
| ADJUST Menu icon. |
2 | Press POINT DOWN button to move a red frame pointer to the |
| item that you want to adjust and then press SELECT button. |
Adjustment dialog box will appear. Press POINT LEFT/RIGHT button to adjust value.
Fine sync
Adjusts an image as necessary to eliminate flicker from the display. Press POINT LEFT/RIGHT button to adjust value.(From 0 to 31.)
Total dots
The number of total dots in one horizontal period. Press POINT LEFT/RIGHT button(s) and adjust number to match your PC image.
Horizontal
Adjusts horizontal picture position. Press POINT LEFT/RIGHT button(s) to adjust the position.
Vertical
Adjusts vertical picture position. Press POINT LEFT/RIGHT button(s) to adjust the position.
Current mode
Press SELECT button to show the information of computer selected.
Clamp
Adjusts clamp level. When the image has a dark bar(s), try this adjustment.
PC ADJUST MENU
PC ADJUST Menu icon
Move a red frame icon to the item and press SELECT button.
| Shows status | |
Selected Mode | (Stored / Free) of the | |
selected Mode. | ||
|
Press POINT LEFT/RIGHT button to adjust the value.
Press SELECT button at this icon to adjust “Clamp,” “Display area (H/V)” or set “Full screen.”
Current mode
Press SELECT button at Current mode icon to show the information of computer connected.
25