COMPUTER INPUT
SELECTING INPUT SOURCE
DIRECT OPERATION
Choose Computer by pressing INPUT button on Top Control or on Remote Control Unit.
If projector cannot reproduce proper image, select correct input source through MENU OPERATION (see below).
INPUT button
Computer
Video
|
|
| MENU OPERATION |
1 | Press MENU button and | ||
| POINT LEFT/RIGHT button to move a red frame pointer to | ||
| INPUT Menu icon. | ||
2 | Press POINT DOWN button to move a red arrow pointer to | ||
| Computer and then press SELECT button. Source Select Menu | ||
| will appear. |
| |
3 | Move a pointer to either RGB (Digital) or RGB (Analog) and then | ||
| press SELECT button. | ||
|
| When your computer is connected to COMPUTER | |
RGB (Digital) |
| ||
|
|
| INPUT (DIGITAL) terminal, select RGB (Digital). |
|
|
| |
| When your computer is connected to COMPUTER | ||
RGB (Analog) |
| ||
|
|
| INPUT (ANALOG) terminal, select RGB (Analog). |
|
|
| |
INPUT MENU
INPUT Menu icon
Move a pointer (red arrow) to Computer and press SELECT button.
Computer
Source Select Menu
Move a pointer to RGB (Digital) or RGB (Analog) and press SELECT button.
SELECTING COMPUTER SYSTEM
This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to “COMPATIBLE COMPUTER SPECIFICATION” on page 23). When selecting Computer, this projector automatically tunes to incoming signal and projects proper image without any special setting. (Some computers need setting manually.)
Note : Projector may display one of the following messages.
Auto
When projector cannot recognize connected signal as PC PC SYSTEM MENU system provided in this projector, Auto PC Adjustment
function operates to adjust projector and the message “Auto” is displayed on SYSTEM Menu icon. (Refer to P24.) When image is not provided properly, manual adjustment is required. (Refer to P25 and 26.)
There is no signal input from computer. Make sure the connection of computer and a projector is set correctly. (Refer to TROUBLESHOOTING on page 40.)
SYSTEM Menu icon Displays system being selected.
SELECT COMPUTER SYSTEM MANUALLY
This projector automatically selects PC system among those provided in this projector and PC system can be also selected manually.
1 | Press MENU button and |
| POINT LEFT/RIGHT buttons to move a red frame pointer to PC |
| SYSTEM Menu icon. |
2 | Press POINT DOWN button to move a red arrow pointer to the |
| system that you want to set, and then press SELECT button. |
PC SYSTEM MENU
SYSTEM Menu icon
Displays system being selected.
The systems on this dialog box can be selected.
Custom Mode (1~5) set in PC
ADJUST Menu. (P25, 26)
22