BOXLIGHT SP-9t manual SETTING-UP Projector, Connecting AC Power Cord, For Continental Europe

Page 8

PREPARATION

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

This projector uses nominal input voltages of 100-120 V or 200-240 V AC. This projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power supply being in use.

Connect a projector with a peripheral equipment before turning a projector on. (Refer to pages 11 ~ 13 for connection.)

CAUTION

For safety, unplug AC Power Cord when an appliance is not used.

When this projector is connected to the outlet with AC Power Cord, an appliance is in Stand-by Mode and consumes a little electric power.

Connect AC Power Cord (supplied) to a projector. The AC outlet must be near this equipment and must be easily accessible.

NOTE ON THE POWER CORD

AC Power Cord must meet requirement of the country where you use a projector. Confirm an AC plug type with the chart below and proper AC Power Cord must be used. If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.

	Projector side	AC Outlet side
		For the U.S.A. and Canada	For Continental Europe
		Ground
	To POWER CORD	To the AC Outlet.	To the AC Outlet.
	CONNECTOR on your	To the AC Outlet.
	CONNECTOR on your	(120 V AC)
	projector.	(120 V AC)	(200 - 240 V AC)
	projector.		(200 - 240 V AC)

8

Image 8

Contents Boxlight SP-9t To the Owner Safety Instructions Voor de klanten in NederlandCompliances Federal Communication Commission Notice Table of Contents Features and Design Compact Design One-Touch Auto PC AdjustmentHOT AIR Exhausted PreparationName of Each Part of Projector For Continental Europe SETTING-UP ProjectorConnecting AC Power Cord Room Light Adjustable FeetPreparation Positioning Projector Preparation Moving Projector Connecting Projector USB Connector Series BTerminals of Projector Audio ComputerConnecting to Computer Terminals ProjectorConnecting to Video Equipment Audio VideoOperation of Remote Control Before OperationBefore Operation Operating Range Remote Control Battery InstallationBattery TOP Controls and Indicators Lamp IndicatorFlow of ON-SCREEN Menu Operation HOW to Operate ON-SCREEN MenuOperating ON-SCREEN Menu Before Operation Menu BAR Guide WindowBasic Operation Turning on / OFF ProjectorTurning on Projector Turning OFF ProjectorAdjusting Screen Zoom AdjustmentFocus Adjustment Keystone AdjustmentSound Adjustment Timer FunctionBasic Operation No Show Function Direct OperationComputer Input Selecting Input SourceSelecting Computer System Select Computer System ManuallyComputer Input Compatible Computer Specifications ResolutionFreq KHzPC Adjustment Auto PC AdjustmentPC Adjust Menu Auto PC AdjComputer Input Manual PC Adjustment Full screen Display areaDisplay area H Picture Image Adjustment Image Level Select DirectImage Level Select Menu Image Select MenuComputer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input Selecting Video System AutoAV System Menu Video or S-VIDEO AV System Menu Component VideoCinema Video Input Image Level Adjustment Provides image at a normal video aspect ratio of 4 Setting Menu SettingSetting Menu To change the code of the Remote Control Unit Power managementRemote control Lamp counter resetMaintenance AIR Filter Care and CleaningCleaning Projection Lens AppendixAppendix Lamp Replacement Lamp Replace CounterTroubleshooting Remote Control Unit Does not workTechnical Specifications Optional PartsAppendix Configurations of the Terminals Control Port ConnectorUSB Connector Series B Computer Input Terminal AnalogPage Limited Warranty