Operating
Operating
WARNING ►When the power is on, a strong light is emitted. Do not look into the lens of projector. Also do not peep at the inside of projector through a hole.
Turning on the power | |
1. | Set the power switch to the ON position. |
2. | Press the STANDBY/ON (projector or |
| |
| remote control) button. |
POWER |
|
(Steady orange) | |
POWER | POWER |
(Blinking in green) | (Steady green) |
Displaying |
| ||
1. | To select an input signal, use the button of INPUT (projector), | ||
| |||
2. | of RGB, VIDEO or SEARCH (remote control). |
| |
To change the aspect ratio, use the button | Focus ring | ||
| |||
3. | ASPECT (remote control). |
| |
To adjust the zoom and focus, use the |
| ||
|
| ||
| zoom knob and the focus ring. |
|
or the buttons
Zoom knob
Turning off the power
This product is able to turn off the main power during the cooling. However, please pay special attention to below two points when you do:
(1)Please do not turn the projector on again for at least 1 minute in this case. Neglect could shorten the lifetime of the lamp.
(2)During use or immediately after use, do not touch around the lamp and vents of the projector. It could cause a burn.
1. | Press the STANDBY/ON (projector or remote control) button. | |
| ||
2. | The message "Power off?" will appear on the screen for approximately 5 seconds. | |
Press the STANDBY/ON (projector or remote control) button again while the | ||
| ||
| message appears. |
The projector lamp will go off, and the POWER indicator will begin blinking in orange. Then the POWER indicator will stop blinking and light in steady orange when the lamp cooling is complete.
3. | Make sure that the power indicator lights in steady |
| |
| orange, and set the power switch to the OFF position. |
POWER
(Blinking in orange)
POWER
(Steady orange)
The POWER indicator will go off.
ENGLISH
7