BenQ PB2240 user manual Color, Tint, Increases or decreases the color intensity of the image

Page 29

Increases or decreases the color intensity of the image.

Color

		This function is not available when a PC input is selected.

	Adjusts the color tones of the image. The higher the value, the more red-
Tint	dish the image becomes. The lower the value, the more greenish the
Tint	image becomes.
		This function is not available when a PC input is selected.
		This function is not available when a PC input is selected.

Operation 25

Image 29

Contents Welcome Disclaimer CopyrightTable of Contents Ordering Parts or Getting Information Iv Table of ContentsImportant Safety Instructions Important Safety InstructionsBut could fail if power cuts or surges Safety Instructions Locations with an ambient temperature Locations near fire alarmsUsing the unit when it is not fully Bedding or any other soft surfaceSafety Instructions Introduction Projector FeaturesIntroduction Shipping Contents Projector Exterior View Optional AccessoriesFront / Upper Side Rear SideControls and Functions Adjusts the focus of the projected image IntroductionExternal Control Panel Turns the projector on or offFunctions Descriptions Remote Control DescriptionRestore the image. Refer to page 21 for more information Remote Control Effective RangeInstalling or Replacing the Battery Connection Connecting to a Laptop or Desktop ComputerConnecting Video and S-Video Devices Connecting Equipment to the Component Video InputVideo devices Video cable Audio cable ConnectionVideo devices Video cable Audio cable IV. Ceiling rear InstallationChoosing a Location Press the adjuster button again to retract the foot Adjusting the HeightZoom ring Installation Screen SizeScreen size chart 169 aspect ratio Screen size chart 43 aspect ratioOperation OperationStart Up Shutdown Disconnect the power cord from the wall socketFor example Digital Keystone CorrectionSource Selection Auto AdjustmentBlank Zoom / FocusingMenu System Menu OperationIng 3 Left / Right 4 on Using the MenusProjector or 3 / 4 on Use 3 Left / Right 4 on the projectorPicture Menu Preset ModeKeystone BrightnessIncreases or decreases the color intensity of the image ColorTint Pro-Picture Menu Volume OSD Time Setting MenuReset MuteAdvance Menu High Altitude Mode Information Menu ResolutionSource Lamp HourCleaning the Lens MaintenanceCleaning the Projector Case Storing the ProjectorMessage Status Lamp InformationReplacing the Lamp For 45 minutes until the lamp has cooled Temp Information IndicatorsLight Status & Description Power Temp Lamp Power events Thermal events Lamp eventsNew one immediately Please contact your dealer for assistanceAccessories included in the standard package Service InformationOptional Accessories not included in the standard package Ordering Parts or Getting InformationPlug the power cord into the AC inlet on TroubleshootingMake sure that it is switched on Cause RemedyProjector Specifications SpecificationsOperating altitude Feet at 30C 6000 ~ 10000 feet at 23C DimensionsEnvironmental Requirements Supported Timing for PC Input Timing ChartSupported Timing for Component-YPbPrInput Supported Timing for Video and S-Video InputsWarranty WarrantyLimited Warranty FCC Statement Regulation StatementsEEC Statement MIC Statement