BenQ PB8250 Setting Up Your Projector, Choosing a Location, Making Connections, IV. Ceiling rear

Page 19

Setting Up Your Projector

Choosing a Location

Your projector is designed to be installed in the four installation configurations shown here: Floor front, Ceiling front, Floor rear, Ceiling rear. Your room layout or personal preference will dictate which installation configuration you use.

I. Floor front

II. Ceiling front

III. Floor rear						IV. Ceiling rear

For further information on the four configurations, please refer to page 31.

If you place the projector above or below the screen, you have to tile it down or up to center the image on the screen, in these situations image distortion will occur. Use the Keystone function to correct the distortion. See page 20 for keystone correction.

Making Connections

When connecting a signal source to the projector, be sure to:

1.Turn all equipment off before making any connections.

2.Use the correct signal cables for each source.

3.Ensure the cables are firmly inserted.

Setting Up Your Projector

Image 19

Contents Welcome Disclaimer CopyrightTable of Contents PIP Picture In Picture Menu Iv Table of ContentsOrdering Parts or Getting Information Supported timing for PC including DVI-I input Table of ContentsVi Table of Contents Important Safety Instructions Important Safety InstructionsSafety Instructions 10000 Safety Instructions Introduction Projector FeaturesIntroduction Shipping Contents Back View Optional AccessoriesProjector Exterior View Front / Upper ViewPC/ YPbPr/ YCbCr Connector PanelExternal Control Panel Controls and FunctionsFront View Remote Control DescriptionRemote Control Effective Range Push and open Install batteries as Installing or Replacing the BatteriesIV. Ceiling rear Setting Up Your ProjectorChoosing a Location Making ConnectionsComponent Video cable Connecting to a Laptop or Desktop ComputerConnecting Equipment to the Component Video Input Audio cableVideo devices or VCR Connecting to Video or S-Video DevicesConnecting to Display Devices Video devices Video cableFocus ring Zoom ring Setting Up Your Projector Adjusting the HeightScreen Size Screen size chart 169 aspect ratio Screen size chart 43 aspect ratioStart Up OperationOperation Shutdown For example Digital Keystone CorrectionSource Selection Auto AdjustmentBlank Zoom / FocusingLaser Pointer Operation PIP Picture In Picture Operation Volume AdjustmentMouse Function Operation Zoom In + / Zoom OutFreeze Preset Mode SelectionMenu System Menu OperationUsing the menus Display Menu Increases or decreases the color intensity of the image ColorTint As aboveColor Temp Image MenuAuto Resize PositionSystem RatioSharpness Treble VolumeSource Menu MirrorBass Adjusts the bass level. -5 ~Mute Control Menu SetupLanguage Reset Preset ModePIP Position PIP Picture In Picture MenuPIP Source PIP SizeCleaning and replacing the air filters MaintenanceCleaning the lens Cleaning the projector caseTransporting the projector Storing the projectorLamp Replacement Use and Replacement of the LampLamp Information Maintenance Temp Warning Light IndicatorsPlease contact your dealer for assistance LEDDealer for assistance Ordering Parts or Getting Information Service InformationAccessories included in the standard package Optional Accessories not included in the standard packageMake sure that it is switched on TroubleshootingCommon Problems & Solutions Plug the power cord into the AC inlet onProjector Specifications SpecificationsTechnical Specifications RS-232C Pin Environmental RequirementsSupported timing for Video and S-Video inputs Timing ChartSupported timing for PC including DVI-I input Supported timing for YPbPr inputUnit mm Dimensions DimensionsLimited Warranty WarrantyWarranty MIC Statement Regulation StatementsFCC Statement EEC Statement

Setting Up Your Projector

Choosing a Location

III. Floor rear

IV. Ceiling rear

Making Connections