Installation
Powering off the projector
1.Press the “Power” button to turn off the projector lamp, you will see a message “Please press power button again to complete the shutdown process. Warning: DO NOT unplug while the projector fan is still running.” displayed on the projector’s screen. Press the “Power” button again to confirm, otherwise the message will disappear after 5 seconds.
2.The cooling fans continue to operate for about 30 seconds for cooling cycle and the Power LED will be quick amber flash. When the Power LED becomes slow flashing, the projector has entered standby mode. If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press “Power” button to restart the projector.
3.Disconnect the power cord from the electrical outlet and the projector.
4.Do not turn on the projector immediately following a power off procedure.
5.Close the lens cap to prevent dust if you like.
Warning Indicator
When the “LAMP” indicator lights solid amber, the projector will automatically shut itself down. Please contact your local reseller or service center.
When the “TEMP” indicator lights solid amber for about 20 sec- onds, it indicates the projector has been overheated. You will see a message “Projector Overheated. Lamp will automatically turn off soon.” on the
Under normal conditions, the projector can be switched on again after it has cooled down. If the problem persists, you should con- tact your local dealer or our service center.
When the “TEMP” indicator flashs amber for about 30 seconds, you will see a message “Fan fail. Lamp will automatically turn off soon.” on the
English ... 14