Safety precautions

Warning;

when use this projector ,please read this manual carefully.

If wrong operation ,it will cause electric shock or fire.so when use and repair this projector ,please comply with the following points

Trouble shooting

TROUBLE SHOOTING

1,Read manual

Before use this projector ,please read full manual carefully and

operate according to this manual instruction

2,Clear

when clear this projector ,please pull out the power cable. Use the wet cloth to clear,not the cleasner

3.Accessory

please use our recommended accessory. Or it will damage the projector.

4,Use environment

Donot place the projector in wet environment 5,installation and fix

please place this projector in stable table . 6, Ventilation

the ventilation in the projector are best

for projector work stably. Donot let the dust wall up the filter. Or it will cause the projector high-temperature protected. So please use the water to clear the filter per month.

7, Power

please make sure the power same as your projector inquiry specification. (220 V or 110V) 8, Earthing wire

this projector has earthing wire . It is three pin plug.

9,protect the power cable Please confirm the power cable are perfect when connect the projector.

10,Thunder

when the thunder happen or long time no use , please pull the power cable out of projector.

11,Repairment

As the high voltage inside ,please donot open or try to repair the projector by yourself. . Please ask a professional technician to repair the projector.

12, Far away Heat device

please make sure this projector far away other heat device . It will damage the projector service life

Please refer to this chapter when you encounter a problem list prior to contacting your dealer.

Problem:	Possible solution(s):
Projector turns off automatically	1, Dust cover the filter ,
	Please wash this filter by water .
	2, Some of fans are broken ,donot turn again,
	It is high temperature protected system.
	Please replace the broken fans quickly.
Lamp doesn't work.	1, Power supplier are wrong . Please confirm your
	Projector power specification . 220V or 110V .
	2 , Lamp are broken or out of service life.
	Please replace the lamp and test it again
	3, Check the ignitor . It is broken , please change a
	New ignitor.