PYLE Audio PP-7200L manual Internal Switch

to host whenever an off line status occurs. Therefore, signals including the paper near end detect will generate busy signal to the host. Consequently, the printing may be stopped even when there is still a long way to go before the paper roll is actually exhausted. Taking the paper out beep into consideration, the printer will keep on beeping at Paper End (completely no paper) till paper is replaced when S1-5 is ON. Yet when S1-5 is OFF, the printer will keep on beeping every 3 seconds at Paper Near End (still long paper in replace) till paper is replaced.

For switch position 6, when it is set to OFF, there will be a 20 mm paper feed before cutting when software does not define this point and there will be further 10 mm paper after cutting to prevent paper jam. Before setting this switch to ON, please make sure that your software will take care of enough paper feed for the paper jam prevention issue.

For switch position 8, when it is set to ON in the field, the printer maybe subject to unpredictable damages and must be strictly prevented.

The factory default for each position is listed below:

Switch Position	1	2	3	4	5	6	7	8
Serial interface w/	OFF	OFF	OFF	OFF	OFF	OFF	OFF	OFF
auto cutter
Parallel interface w/	ON	ON	OFF	OFF	OFF	OFF	OFF	OFF
auto cutter
USB interface w/ auto	OFF	OFF	OFF	OFF	OFF	OFF	OFF	OFF
cutter
LAN interface w/ auto	OFF	OFF	OFF	OFF	OFF	OFF	OFF	OFF
cutter

INTERNAL SWITCH

There is an extra internal 4 position DIP switch in PP-7000II series for more technical settings. To access these setup, please first turn off the printer power and disconnect every cable from the printer. Remove 4 screws from bottom of printer and remove the plastic bottom cover with the power switch pressed. The 4 position DIP switch seats beside the 8 position DIP switch for setup window with the switch position counting starts from the nearest side to the 8 position DIP switch.

This 4 position DIP switch works as following:

ê	Switch position	Setting Effect
	Function	ON	OFF
1	Factory internal setting	Disable	Default
2	Paper width	58 mm	80 mm
3	Line format	576 dots / line	512 dots / line
4	Reserved	N. A.	N. A.

Part 19