Operation, Startup | 3M MP7730B, MP7630B instruction

Operation

Startup

Power

✓Note: Make all cable connections and line hookups with the power off.

Ground lead

The 2-prong adapter with ground is used with older U.S. electrical outlets that only support 2-prong power cord plugs.

✓Note: When using this adapter, the ground lead MUST be securely fastened to the ground screw on the outlet.

Plug the 2-prong adapter into the bottom socket of the eletrical outlet. Hook the end of the ground lead firmly around the neck of the outlet’s ground screw. Tighten the screw, if necessary, to hold the ground in place. Then plug the power cord into the adapter.

Standby/ON

Standby/On

1.Plug power cord into wall socket. Wait 5 seconds before pressing the Standby/On button.

2.Press the Standby/On button and hold for 3 seconds.

•The ON indicator will blink green during warm-up and lamp ignition.

(When power is turned off, there is a 90-second reset period before the Standby/On button will function again.)

3. Turn on all connected equipment.

✓ Note: If you have the Optional Video Module attached to the unit, press the Source button on the remote to select the source of the signal to be projected onto the screen. The selected signal input is displayed at the top right of the screen. The display will show the last selected input source before power was turned off. (For more information, please refer to the Optional Video Module section of this manual.)

3M™ Personal Projector MP7630B/MP7730B