Knoll HD290, HD292, HD178 user manual

Page 20

20

When Autosource is not checked, the projector defaults to Component initially, then defaults to whatever the last active source was when the projector was powered down. To display another source, you must manually select one by pressing the Source button on the remote or keypad. This cycles through all the sources that are selected in the Source Enable menu.

The Source 1, 2, and 3 menus in the Sources menu allow

Sources

Source Enable

you to assign a source to the Source 1, 2, and 3 buttons

 

 

on the remote. The Source 4 menu selection would

 

 

apply to the Custom key if that option is chosen in the

 

 

Custom key menu, see page 21.

 

 

To use the SCART RGB source, you must first select it in the Source Enable menu (the projector cannot automatically detect this source). Enabling SCART will disable Component and Composite sources.

System>Rear: reverses the image so you

can project from behind a translucent screen.System menu Ceiling: turns the image upside down for

ceiling-mounted projection. Auto Ceiling: uses an internal sensor to automatically turn on ceiling mount mode if the projector

is inverted. High Power: maximizes the light

output of the lamp. Auto Power: When Auto Power is checked, the projector automatically

goes into the startup state after the projector receives power. This allows control of ceiling mounted projectors with a wall power switch Display Messages: displays status messages (such as “Searching”) in the lower-left corner of the screen.

Translucent OSD: makes the menus translucent. This prevents the image from being completely

covered by the menus while you are making image adjustments. Sleep Timer: automatically

turns off the projector after 4 hours. Power Save: automatically turns the lamp off after no signals are detected for 20 minutes. After 10 additional minutes with no signal, the projector powers down. If an active signal is received before the projector powers down, the image is displayed.

Startup Logo: allows you to display a blank screen or a custom captured image (HD108 only) instead of the default screen at startup.

To capture a new image, display the image and select

 

 

Capture New. A message appears. Select Captured in

Startup logo

Blank Screen

the Startup Logo menu to display your new image.

 

 

Note that this feature will not work on interlaced signals.

 

 

Blank Screen: determines what color is displayed when

 

 

you select Blank Screen in the Startup Logo menu

 

 

and when no source is displayed.

 

 

Language: allows you to select a language for the

 

 

onscreen display.

 

Language

Image 20
Contents HD108 HD178 HD290 HD292 Safety Certifications FCC WarningDeclaration of Conformity TrademarksTable of Contents ’ / 1 m Product specifications Accessories IntroductionVolt DC output Rear Connector Panel VideoHdmi M1/DA/DVI Setting up the Projector Projector PositioningChoosing the aspect ratio HD108 Projection Throw Distance 169 Video ScreenVideo Connectors Component RCA Connecting a video deviceDigital connections Video connectionComputer connections Displaying an imageShutting down the projector Power Save Sleep TimerTroubleshooting your setup Turning off the projectorPage Page Using the remote control Troubleshooting the remoteUsing the keypad buttons Still need assistance?Customizing the projector Using the menusOptimizing video images Picture menu Horizontal/Vertical Position adjusts the position of a Advanced menuSettings menu Page Page Wait 60 minutes to allow the projector to cool thoroughly Maintenance Cleaning the lensReplacing the projection lamp Appendix LED BehaviorProjector dimensions for ceiling mount installations Remote control discrete codesRS-232 terminal specifications for HD178 and HD290 Communication configurationFunction Command Response AAASupported commands Function Command Range Default TSA VPSVSU = SecamPage Limited Warranty