LG Electronics LCD 782LS Adjustment for White Balance, Adjustment Start, Adjustment for Edid

ADJUSTMENT

All adjustment are thoroughly checked and corrected 2.		Adjustment for White Balance
when the monitor leaves the factory, but sometimes		1)	Display Black pattern at SXGA/60Hz.
several minor adjustment may be required.		2)	Set External Bright to MAX position and Contrast to
Adjustment should be following procedure and after			80 Position.
warming up for a minimum of 10 minutes.		3)	Select PRESET START → BIAS CAL command
• Alignment appliances and tools.			and Enter.
		4)	No attempt to manually adjust, BIAS data is auto-
- IBM compatible PC
			matically adjusted and saved to the EEPROM.
- Programmable Signal Generator.
		5)	Display Full White pattern at SXGA/60Hz.
(eg. VG-819 made by Astrodesign Co.)
		6)	Select DRIVE CAL command and Enter.
- E(E)PROM with each mode data saved.
		7)	9300K are automatically adjusted and
1. Adjustment Start			saved to the EEPROM.
		8)	Select PRESET EXIT command and Enter.
1) Display any pattern at any Mode.
2) Run alignment program for LB782G on the IBM	3.	Adjustment for EDID
compatible PC.
		1)	Use this procedure only when there is some
3) Select EEPROM → ALL INIT command and Enter.
			probelm on EDID data.
4) This will make all data to default state.
		2)	Connect the D-sub cable.
5) Select COMMAND → PRESET START command
		3) Select EEPROM → EDID(A) WR command and
and Enter.
			Enter.

A

9

6

IBM

15

5

1

Video Signal

Compatible PC

11

10

6

Generator

5

1

C

used

PARALLEL PORT

13

1

Not

25

14

RS232C

OFF

ON

5V

F

Line

PARALLEL

C

Control

5V

Power inlet (required)

4.7K

220

ON

5V

4.7K

POWER

Power Select Switch

E

VGS

(110V/220V)

OFF

74LS06

A

MONITOR

ST

Power LED

4.7K

V - SYNC

74LS06

B

E ST Switch

B

F

V-Sync On/Off Switch

(Switch must be ON.)

Figure 1. Cable Connection

- 11 -