LG Electronics L1953HM, L1953HR, L1753HR, L1753HM manual To remove the Stand Base

Page 7

Connecting the Display

To remove the Stand Base:

1.Hold the body of the Stand as it follows.

3. Pushing Latch inside, Take the stand base from stand body.

2. Press the two latches at the same time as it follows.

4. The body of the Stand and the Stand Base are successfully separated.

A6

Image 7

Contents L1753H L1953H L1753HM L1953HM L1753HR L1953HR On Safety Important PrecautionsOn Disposal On InstallationOn Cleaning On RepackingConnecting the speaker Connecting the stand Connecting the DisplayTo remove the Stand To remove the Stand Base Tilt Range -5˚~20˚ Positioning your displayErgonomic L1753HM / L1953HM Height Range maximum 2.36 inch 60 mm Power Cord Using the ComputerRear Side JackOSD LOCKED/UNLOCKED Control Panel FunctionsFront Panel Controls Control FunctionControlFunction Auto Image AdjustmentPower Button Power IndicatorScreen Adjustment On Screen Display OSD Control AdjustmentMain menu Sub-menu Reference On Screen DisplayOSD Selection and AdjustmentSub-menus Blue Contrast GammaRED GreenOSD Position White Balance PhasePower Indicator Factory ResetUser Flatron F-ENGINEOSD Unlocked will appear TroubleshootingIs the power cord of the display connected? Do you see OSD Locked when you push Menu button?Screen color is mono or abnormal Screen blinksHave you installed the display driver? Power cord ResolutionPower Power Input EnvironmentalWeight ResolutionPower DimensionsWeight DimensionsPower cord Audio Plug&Play PowerDimensions Weight Tilt Range Power InputPreset Modes Resolution SpecificationsIndicator Pin SignalDVI-D Signal Connector Pin AssignmentWall mount plateSeparate purchase Installing the Wall mount plateKensington Security Slot Digitally yours