Plus UP-1100 user manual J u s t i n g t h e C t u r e e l e m e n t s

Selecting the starting mode for the next use of the unit

Set “STARTING RGB” to “LATEST” to use the most recent settings (RGB STANDARD or CUSTOM 1 to 5) when you turn on the unit next. If you set “STARTING RGB” to “STANDARD,” the unit will select the most suitable resolution every time you turn on the unit.

1Carry out steps 1 to 4 in “Storing the most recent settings” on the previous page.

2Press the cursor/ key to select “STARTING RGB.”

3Press the cursor +/– key to select either “LATEST” or “STANDARD.”

4Press L-CLICK.

The change of settings will be confirmed.

Resetting the present settings to factory settings

To reset the changed “PICTURE ADJ,” “FINE PICTURE,” “H POSITION,” and “V POSITION” to the factory settings, carry out the following steps.

1Carry out steps 1 to 4 in “Storing the most recent settings” on the previous page.

2Press the cursor/ key to select “RESET.”

The horizontal frequency of the present incoming signal appears under the title “RESET.”

3Press and hold down the cursor + key for more than three seconds until “COMPLETE” appears instead of the hori- zontal frequency.

Resetting the present settings and all the custom memories to factory settings

Note

If you carry out this procedure, not only the custom memories but also all the menu items except for “LAMP USAGE,” and “LANGUAGE” will be reset.

1Carry out steps 1 to 4 in “Storing the most recent settings” on the previous page.

2Press the cursor/ key to select “ALL RESET.”

3Press and hold down the cursor + key for more than three seconds until “COMPLETE” appears under the title “ALL RESET.”

A d j u s t i n g t h e

p i c t u r e e l e m e n t s

The picture elements such as brightness, contrast, white balance, and so on can be adjusted individually for each input source. The adjustable items vary depending on the input source and “INPUT MODE” setting (see page 24).

		Input source
( T h e e l e m e n t s	VIDEO	RGB
marked with “•” are	S-VIDEO	INPUT MODE (See page 24.)
adjustable.)		RGB	YCbCr
BRIGHTNESS	•	•	•
CONTRAST	•	•	•
COLOR	•	–	•
TINT	•	–	•
SHARPNESS	•	–	–
WHITE BALANCE	•	•	•

1Select the input source (see page 16 or 21).

2Press MENU to display the main menu.

3Press the cursor / key to select “IMAGE ADJ MENU.”

4Press L-CLICK to display the IMAGE ADJ MENU.

5Press the cursor / key to select “BRIGHTNESS,” then press the cursor +/– key to adjust the brightness.

6Press the cursor / key to select “CONTRAST,” then press the cursor +/– key to adjust the contrast.

7Press the cursor / key to select “COLOR,” then press the cursor +/– key to adjust the color.

If the input source is RGB and “INPUT MODE” is “RGB,” skip this step and go to step 10.

8Press the cursor / key to select “TINT,” then press the cursor +/– key to adjust the tint.

Note

The tint control doesn’t operate with a PAL or SECAM source.

9Press the cursor / key to select “SHARPNESS,” then press the cursor +/– key to adjust the sharpness.

If the input source is RGB, skip this step and go to the next step.

10Press the cursor / key to select “WHITE BAL- ANCE,” then press L-CLICK.

The WHITE BALANCE menu appears.

11Press the cursor / key to select each item in the WHITE BALANCE menu, then press the cursor +/– key to adjust the item for the white color balance.

E – 27