Setting up your projector (continued)
TRIGGER terminal
The TRIGGER terminals on the rear of the projector are terminals that output 12 V signal to control externally connected devices (electric screens) when images are projected.
Ring (NC) |
| To TRIGGER 1 |
| or TRIGGER 2 | |
|
| |
|
| terminal |
|
| To externally |
(Ground 0 V) | Tip (12 V) | connected |
device |
To use the TRIGGER terminals, set TRIGGER 1 (POWER) or TRIGGER 2 (ANAMO) to ON in the INSTALLATION menu. (The factory default is OFF. See page 32 for details.) Use the following steps to change the setting.
With the INSTALLATION menu: (See page 29 for menu setting.)
1.Display the INSTALLATION menu.
2.Select TRIGGER 1 (POWER) or TRIGGER 2 (ANAMO) by pressing the p or q button.
3.Select ON by pressing the t or u button.
To cancel the menu:
4. Press the MENU button.
Caution:
•Do not use the signal output from the TRIGGER terminals as power for other devices.
•Do not link the TRIGGER terminals with audio terminals of other devices because that devices may be damaged.
•The rated current for the TRIGGER terminals are 200 mA. If you use a current exceeding this rating, a failure may occur.
•For information about electric screens, please contact screen manufacturers.