Mitsubishi Electronics SE2U user manual Compliance Notice of FCC

Page 9

COMPLIANCE NOTICE OF FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced Radio / TV technician for help.

Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate this equipment.

COMPLIANCE NOTICE OF INDUSTRY CANADA

This Class B digital apparatus complies with Canadian ICES-003.

Declaration of Conformity

Model Number :

SE2U

Trade Name :

MITSUBISHI ELECTRIC

Responsible party :

Mitsubishi Digital Electronics America, Inc.

 

9351 Jeronimo Road, Irvine, CA 92618 U.S.A

Telephone number :

+1-(949) 465-6000

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Trademark, Registered trademark

Macintosh is registered trademark of Apple Computer Inc.

DLP™, Digital Micromirror Device and DMD are all trademarks of Texas Instruments. Other brand or product names are trademarks or registered trademarks of their respective holders.

Important Safeguards

5

Image 9
Contents SE2 Compliance Notice Contents Dimensions Important safeguards Important Safeguards Never remove the cabinet Do not modify the projector Place of installation Compliance Notice of FCC Introduction Shipping ContentsProjector Exterior View Connector PanelFront / Upper Side Rear SideExternal Control Panel Controls and FunctionsFunctions Descriptions Remote Control DescriptionInstalling or Replacing the Battery Remote Control Effective RangeConnection Connecting to a Laptop or Desktop ComputerConnecting Video and S-Video Devices Connecting Equipment to the Component Video InputConnecting to Display Devices Choosing a Location InstallationScreen Size Adjusting the HeightScreen size chart 43 aspect ratio Start Up OperationShutdown For example Digital Keystone CorrectionSource Selection Auto AdjustmentZoom / Focusing MuteSlide Operation Still Mode SelectionMenu System Menu OperationUsing the Menus Mode Picture MenuKeystone BrightnessTint ColorPro-Picture Menu Volume OSD Time Setting MenuReset Audio MuteAdvance Menu Information Menu ResolutionSource Lamp HourCleaning the Lens MaintenanceCleaning the Projector Case Storing the ProjectorLamp Information Interval of lamp replacementReplacing the Lamp Temp Information Resetting the lamp counterIllustration IndicatorsLight Status & Description Power Temp Lamp Lamp events Accessories included in the standard package Service InformationOptional Accessories not included in the standard package Ordering Parts or Getting InformationProjector does not Turn on TroubleshootingProjector Specifications SpecificationsSupported Timing for PC Input Timing ChartSupported Timing for Component Video-YPbPrInput Supported Timing for Video and S-Video InputsDimensions Mitsubishi Electric Corporation