Telex ANRTM 150 Microphone Bias Voltage Requirements, Optional Aircraft Power Supply Module

Page 4

Microphone Bias Voltage Requirements

The boom microphone requires a bias voltage of 8-16 VDC through 300 to 1000 ohms. If you are uncertain whether your avionics equipment meets this requirement, consult the avionics equipment manufacturer.

Optional Aircraft Power Supply Module

The power supply module is designed for use in negative ground electrical systems only. Do not attempt to use with positive-ground electrical systems.

Installing a Battery in the Optional Battery Module

The battery module requires one 9 volt battery. Alkaline batteries are rec- ommended for best performance. Do not use nickel-cadmium recharge- able batteries or lithium batteries.

1.Slide the battery door over in the direction of the arrow, then up to remove the battery door.

2.Snap the battery onto the battery connector and place the battery into the case.

3.Slide the battery door back into place.

Page 2

Image 4
Contents Telex Page Design Features See Figure General DescriptionInstalling a Battery in the Optional Battery Module Optional Aircraft Power Supply ModuleMicrophone Bias Voltage Requirements Headset Operation Microphone Placement Specifications Receivers and Noise Reduction CircuitsGeneral Ordering InformationLimited Warranty Valid only in United States and Canada Customer Service Page Rev B