Mitsumi electronic LDT37Iv manual Parts Name and Functions, Control Panel, English-6

Page 8

Parts Name and Functions

Control Panel

OFF ON

EXIT

8

7

6

5

4

1POWER button ()

Switches the power on/off. See also page 18.

2MUTE button

Switches the audio mute ON/OFF.

3INPUT button

Acts as SET button with OSD menu.

(Toggle switches between [RGB1], [RGB2], [RGB3], [DVD/HD], [VIDEO<S>] and [VIDEO] .)

4PLUS (+) button

Acts as (+) button to increase the adjustment with OSD menu. Increase the audio output level when the OSD menu is turned off.

5MINUS (-)button

Acts as (-) button to decrease the adjustment with OSD menu. Decreases the audio output level when the OSD menu is turned off.

6UP ( ) button

Activates the OSD menu when the OSD menu is turned-off. Acts as button to move the highlighted area up to select the adjustment with OSD menu.

7DOWN ( ) button

Activates the OSD menu when the OSD menu is turned-off. Acts as button to move the highlighted area down to select the adjustment with OSD menu.

9

10

Button Location

INPUT MUTE

3 2 1

8EXIT button

Activates the OSD menu when the OSD menu is turned-off. Acts as EXIT button to move to previous menu with OSD menu.

9Remote control sensor and Power indicator

Receives the signal from the remote control (when using the wireless remote control). See also page 8.

Glows green when the LCD monitor is in active and glows red when the LCD is in POWER OFF mode. When the LCD is in power save mode, it will glow both green and red. When SCHEDULE is enabled, it willl blink green and glow red. See page 19. In the case of where a failure is detected, it will blink red.

10Main Power Switch

On/Off Switch to turn main power on/off.

NOTE: Control Key Lock Mode

This control completely locks out access to all Control Key functions. To activate the control key lock function, press both of ““ and ““ and hold down simultaneously for more than 3 seconds. To resume back to user mode, press both of ““ and ““ and hold simultaneously for three (3) seconds.

English-6

Image 8
Contents Page Page Index Advanced OptionImportant Information Canadian Department of Communications Compliance StatementFCC Information English-2English-3 DeclarationDeclaration of the Manufacturer English-4 Recommended UseErgonomics Contents English-6 Parts Name and FunctionsControl Panel Terminal Panel DVD/HD in BNCAudio OUT Video IN/OUTWireless Remote Control English-8English-9 Setup Procedure Installing and removing stand To prevent the main power switch From being changedHow to install stand How to remove the standEnglish-12 Upright position Lay the screen face downVentilation Requirements for enclosure mounting Wiring Diagram ConnectionsBefore making connections English-13Connecting a Personal Computer English-14English-15 Connecting with Digital Interface EquipmentConnect the LCD Monitor to a Computer with a Digital Output English-16 Connecting a DVD Player with component outConnect the LCD Monitor to a DVD Player English-17 Power on and OFF Modes Pressing the Main Power SwitchPressing the power button Using the remote controlPower Indicator English-19OSD On-Screen-Display Controls Picture Reset Clock PhaseColor Color ControlZoom Mode ResolutionScreen Reset Audio ResetPIP Reset ConfigurationAuto Setup Auto AdjustReset Factory ResetScreen Saver Color SystemOFF Timer OSD Turn OFFInformation OSD OSD H PositionInput Resolution Scan ModeFilm Mode Advanced OptionImage Sticking of LCD Panel Recommendations English-28Controlling the LCD monitor via RS-232C Remote Control English-29Power on English-30Features English-31Troubleshooting English-33 SpecificationsSpecifications Pin Assignment English-34Mitsubishi Contact Information