Mics connection, Mic with Remote Key Control

Getting connected (cont.)

Mic(s) connection

Using a mic cable with a 1/4” end, connect the mic to either of the DA-3700PRO’s microphone inputs.

A mic with Remote Key Control

Connect the Remote Key Control cable into the KEY CONTROLLER jack on the rear panel of the DA-3700PRO.

Effects Loop connections

Source Music (Music from a DVD or CD player)

By using the built-in Effects Loop you can add ef- fects such as a professional Digital Key Controller to the source player’s music without compromising the quality of the original signal. To use the effects loop connect an RCA cable from the DA-3700PRO’s EFFECTS LOOP L or R OUT jack to the effects unit input. Then connect an RCA cable from the effects unit output, into the DA-3700’s L or R IN jack.

Vocals

The MIC INSERT jacks on the rear panel allow you to loop the vocals through an effects unit. NOTE: In or- der to do this you must have a 1/4” Y adapter cable (not included) for each microphone line.

Connect the single end of the Y cable into the MIC INSERT jack. Connect one side of the double end into the input on the effects device and the other end into the output of the effects device.

NOTE: If the Y cable is plugged into the DA-3700PRO but the double ends are not connected to the IN and OUT of a device, there will be no sound. So if you are not using effects, be sure the Y cable is unplugged.

Vovopro DKC-100

To OUT

To IN

To OUT

To IN

NOTE: If you are not using the Effects Loop, be sure the LOOP BARS are re-connected. Without these, there will be no sound.

Y Adapter Cable

Vocopro VSPM-1

To OUT To IN