Detaching Network Display from Its Stand

Alternate Mounting Solutions

Detaching Network Display from Its Stand

Unscrew screws n the swivel base support column and pull downo the hinge to release.

Interface for Arm/ Wall Mount Applications

Before installing to mounting device, please refer to Fig.1-3. The rear of this LCD display has four integrated 4 mm, 0.7 pitch threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

Note: M4mm x 11mm (L) screws should be used for a 3mm thick mounting plate application. Thicker plates should use appropriately longer screws. The screw threads should extend between 8 and 10 mm beyond the display surface of the mounting plate. Follow the mounting device manufacturer’s reccomendations.

Connecting the Display to Your Network

1.Make sure the AC Power Cord is disconnected

2.Connect one end of the Ethernet cable to the Network Display’s Ethernet (ENET) port. (See Fig 1-5)

3.Verify that the other end of the Ethernet cable is connected to your LAN/WAN network.

4.Make sure connections are secure and that the Ethernet connectors have “clicked” into place.

Figure 1-3

Figure 1-4

Figure1-5