Planar PL2210MW manual Important Safety Instructions

Page 4

Important Safety Instructions

Please read the following instructions carefully. This manual should be retained for future use.

1.To clean LCD Monitor screen;

--Power off LCD Monitor and unplug the AC Cord.

--Spray a non-solvent cleaning solution onto a rag.

--Gently clean the screen with dampened rag.

2.Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or sunlight can severely damage it.

3.Do not apply pressure to the LCD screen. Excess pressure may cause permanent damage to the display.

4.Do not remove the cover or attempt to service this unit by yourself. Servicing of any nature should be performed by an authorized technician.

5.Store LCD Monitor in a room with a room temperature of -20° ~ 60°C (or -4° ~ 140°F). Storing the LCD Monitor outside this range could result in permanent damage.

6.If any of the following occurs, immediately unplug your monitor and call an authorized technician. * Monitor to PC signal cable is frayed or damaged.

* Liquid spilled into LCD Monitor or the monitor has been exposed to rain. * LCD Monitor or the case is damaged.

7.Only use the supplied main lead to connect the monitor. For a nominal current up to 6A and a device weight above 3 kg, a line not lighter than H05VV-F, 3G, 0.75 mm2 must be used.

Important Recycle Instruction:

LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG. FOR LAMP SPECIFIC DISPOSAL INFORMATION CHECK WWW.LAMPRECYCLE.ORG.

Contains Mercury, Dispose of Properly

3

Image 4
Contents Page Contents Preface FCC Statement WarningImportant Safety Instructions Installation UnpackingConnecting the LCD Monitor and Base Viewing Angle AdjustmentConnecting the Display Detaching LCD Monitor from Its StandConnecting the AC Power Connecting the Audio CableSetting Up the LCD Monitor Power Management SystemDisplay Controls User ControlsMenu/Enter Auto/ExitSub Adjusting the Monitors DisplayDescription Full AspectOSD SUB9300 75005000 UserSpecifications Technical InformationPower Management TmdsStandard Timing Table Sync TOTAL/ Active Front Back Pixel Timing Name Troubleshooting Problem Picture is unclear and unstableCables, Replacement Lamps, Accessories Technical Support Product Registration and Technical SupportRegister Your Planar Products Today Planar Support